TURNTABLE AUTO-STOP FUNCTION
Some longer vinyl records will stop playing before the last track has finished, because the auto-stop area is set
outside the unit's pre-set area. If that is the case, move the AUTO-STOP Switch (42) to the "OFF" position, the
tone arm will then carry on to the end of the record. However, the turntable will continue rotating and will not stop
automatically. To stop the turntable rotating, turn the unit off or switch the AUTO-STOP switch back to "ON". Then
return the Tone Arm to its rest (38). Note: with the Auto-Stop switch set at the "OFF" position, the turntable will
start rotating as soon as Phono function (17) is selected.
STYLUS REPLACEMENT
When the stylus eventually needs replacing, a universal sapphire needle or stylus (suitable for 45/33/78rpm records)
is available for purchase direct from the manufacturer. Please contact your supplier or Steepletone Products direct
for information on how to purchase one.
REPLACING THE STYLUS
(1) To remove the Stylus from the Tone Arm, hold the Tone Arm Head steady, while grabbing the red plastic stylus
holder with two fingers - then gently pull the complete red stylus holder towards you and down, as shown in the
diagram below
.1.
(2) To fit another Stylus, hold the sides of the red plastic stylus holder, ensuring the needle is facing downwards.
Gently push the back of the stylus holder against the black cartridge at the end of the tone arm and clip it
upwards, until you are sure it is securely fitted. Refit the protective needle cover, if so required.
(3) To remove the whole Stylus assembly from the Tone Arm, hold the Tone Arm Head steady, lift up the black tab
above the stylus holder .1. (1) whilst grabbing the red plastic stylus holder with two fingers - then gently pull the
complete red stylus holder and tone arm cartridge downwards, as shown in the diagram below .1. (2).
(4) To remove the whole Stylus/pick-up assembly, use small pliers to carefully disconnect the wires .2., then change
to another stylus cartridge and connect the wires to the new stylus again with the pliers. (Do not pull the
pick-up wires directly as this may cause damage to the wires). Refit as in Diagram .3. (1) (2).
NOTE: Always handle the stylus with care as the sapphire needle tip is easily damaged. When transporting
the turntable it is advisable to refit the protective needle cover until the unit is going to be used again. When
removing or re-fitting the stylus, always be careful not to put too much pressure on the stylus holder and the
tone arm cartridge, to avoid causing any possible damage to them.
LISTENING TO CASSETTE TAPE
GENERAL OPERATION
Press the " TAPE " Function button (16) to activate the Tape/Cassette Mode:
Cassette Playback
Stop and Ejection
Fast forward
(2).
The system will start playback automatically after inserting a pre-recorded cassette tape.
Press the " Tape Forward / Eject " button (34) completely inwards - the cassette tape will be
ejected though the Cassette Door Cover (35).
The " Tape Forward / Eject " button (34) will stay at the lowest height position.
Press the " Tape Forward / Eject " button halfway in during Playback Mode - the tape will wind
in a forward direction. The " Tape Forward / Eject " button will stay at mid-height position.
Slightly press the " Tape Forward / Eject " button in again to resume normal playback - the
" Tape Forward / Eject " button will resume the highest position
E-3
.
Need help?
Do you have a question about the SMC922 and is the answer not in the manual?
Questions and answers
how do I replace the drive belt on the cassette player for the BTSMC922