Removing The Cutting Unit; Removing The Belts - Husqvarna Rider Pro 15 Operator's Manual

Removing the cutting unit

WARNING!
Wear protective glasses when
removing the cutting unit. The
spring which tensions up the belt
can go off and cause personal
injury.
1. Carry out steps 1-9 to put the cutting unit in the
service position, see "Service position for
cutting unit" on page 34.
2. Remove the bolt and lift off the cutting unit.
To fit the cutting unit simply reverse the procedure
for removal. See page 29 for instructions on fitting
the BioClip 90 deck.
When fitting: Make sure that the "tongue" on the
deck engages with the hole in the underside of the
machine.
Removing the belt
Starting point when Removing the belt:
• No unit attached to the Rider.
• The front part of the belt hangs loose.
The entire belt is only dismantled as set out below,
when the snow plough is fitted on the Rider.
• Remove the guide plate from underneath the
drive wheel. Use a 13 mm spanner.
• Prise the belt off the middle pulley and remove
the belt.
Reverse the above sequence to refit the belt.
MAINTENANCE
33
English –