Page 2
FOLLOW THESE INSTRUCTIONS user guide Thank you for choosing a Cosatto product. Please take a little time to read the important safety notes detailed below. This will ensure many years of happy, safe use. The instruction manual should be kept safely with child car seat for its life period: There is a slot at the rear of the child car seat for storage of the instruction manual.
Page 3
Never use the child car seat without its fabric cover because the seat cover constitutes as an integral part of the child car seat performance. The seat cover should not be replaced with any other than the ones recommended by Cosatto. •...
as those which applied to earlier designs which do not carry this notice. 4 This child restraint is only suitable if the vehicle is fitted with a type approved lap/3 point/static/with retractor safety belt, in compliance with standard UN / ECE Regulation No.16 or other equivalent standards.
Page 5
6 - installation of the car seat 9 to 18kg (group 1 - approx. 9 months to 4 years old) - part 2 Adjust the child car seat to the most reclined position (a). See step 4. Remove both shafts by releasing the end from its lock (b) and pulling the shafts out of the seat (c).
Page 6
sections which is designed to fit low down on your child’s body. Pull the adjuster strap forward (i) making sure the harness is a comfortable but FIRM fit around your child. Finally, pull both chest pads down (j) from your child’s shoulders onto their chest. Note: The chest pads are an important safety feature.
Page 7
Note: The harness, chest pads, crotch pad & chest pad locking bar should be stored away safely for future use. The chest pad locking bar MUST NOT be used in group 2 & 3 installations. Release the vehicle seat belt lock (a) under the headrest. Feed the vehicle seat belt into the gap (b) under the vehicle seat belt slot until the vehicle seat belt is located in the vehicle seat belt slot.
Page 8
Seat: Starting on one side carefully pull the cover off the seat (f). At the rear of the backrest lift the elastic strap over the headrest (g). Push the harness adjuster strap through the elastic loop under the harness adjuster flap (h) then pull the cover from around the adjuster button (i).
Page 9
through the seat and back up from underneath (d). Flatten the clips to secure. Loosening the cover around the waist harness mounting points will help with access. 20 - refitting the harness for group 1 use - part 3 Feed the shoulder harness through the chest pads then push the straps through the slots in the upper seat liner and backrest (a).
Page 10
For the contact information for your local distributor please refer to http://www.cosatto.com/stockists If you are a UK or Ireland customer, please contact us at spares@cosatto.com Headrest cover Upper seat liner...
Page 28
SIGN UP SIGN UP log onto cosatto.com/3towin join the conversation... @Cosatto_Tweets follow us on... facebook.com/clubcosatto...
Need help?
Do you have a question about the HUG Nitty Gritty and is the answer not in the manual?
Questions and answers