Images; Operating Protocol - JVC VN-H37U Instructions Manual

Images

H.264 Profiles
High profiles can maintain high image quality
with a low bit rate, but as the decoder needs to
support high profiles, the processing load on the
decoder becomes heavier.
Compared to high profiles, baseline profile offers
lower compression performance, but the
processing load on the decoder will be reduced.
Selecting high profiles is recommended if the
decoder has sufficient processing ability.
The camera supports both the H.264 Baseline
Profile and H.264 High Profile standards.
PTZ (Pan, Tilt, Zoom)
This camera has a digital PTZ function. While
monitoring, the function can cut out an arbitrary area,
move within the range of shooting and enlarge the
image as if you were operating a PTZ camera.

Operating protocol

PSIA
This device conforms with PSIA (Physical
Security Interoperability Alliance) specifications.
PSIA is an organization whose aim is to promote
the interoperability of IP-enabled security devices.
Initial user name and password are set as follows:
User name: psia
Password: jvc
The RTSP of this device complies with
RFC2326. You can set up to 3 encoders. The
RTSP URL for each encoder is as follows:
Encoder No.1
rtsp://192.168.0.2/PSIA/Streaming/channels/0
Encoder No.2
rtsp://192.168.0.2/PSIA/Streaming/channels/1
Encoder No.3
rtsp://192.168.0.2/PSIA/Streaming/channels/2
ONVIF
This camera supports ONVIF (Open Network Video
Interface Forum). ONVIF is a forum that is
standardizing surveillance device network protocols.
Protocols for discovery of surveillance devices,
acquisition and modification of surveillance
device settings, and audio/video data transfer
are standardized under ONVIF.
The initial user name and password are set as follows:
User name: admin
Password: jvc
This camera fulfills the ONVIF test specification 1.02.
SD Cards
This unit can record the images you shoot in an SD
card (sold separately) inserted in the card slot.
Memo:
● Do not leave the SD card slot cover open for
a long period of time.
Dust may enter inside and cause
malfunctions.
● Use SD cards with a guaranteed operation
temperature of 85 degrees C or higher.
Use the following SD cards.
SDHC cards (4 to 32 GB) of Class 10 or above
Memo:
● The following SD cards are confirmed to
function correctly with this camera:
Panasonic: RP-SDW04GJ1K
Toshiba: SD-FX004G
SanDisk: SDSDX-004G-J95
● Make sure to set [SD Card] on the Record
page to [Disuse] (A Page 41) before
removing an SD card or turning off this
camera.
● When using an unsupported SD card, it can
be set to record, but recording errors may
occur.
● Operation of all SD cards that meet the above
conditions is not guaranteed.
Recording to SD cards
Memo:
● Only encoding channels of either H.264 High
or H.264 Baseline with a bit rate of 1024 kbps
or lower can be recorded to the SD card.
Configure settings via the Encoding Page
(A Page 24) before you start recording.
● Refer to "Approximate Recording Time" for
recording time to an SD card. (A Page 113)
7