Post Error Messages - NEC Express5800 User Manual

2-16 General Description
4.
If your server uses onboard serial ATA (SATA) RAID feature, the following message is
displayed on the screen to prompt you to run Array Configuration Utility (ACU).
Press <Ctrl><A> for Configuration Utility!
Press Ctrl + A to run ACU. For detail explanation, see Chapter 4.
5.
If the server has an optional RAID controller or SCSI card, POST displays the message
prompting you to launch the RAID configuration utility and the disk array BIOS setup
utility.
Example:
Press <Ctrl><A> for SCSISelect(TM) Utility!
Refer to the manual supplied with the disk array controller for detail instructions.
POST will automatically proceed a few seconds later.
6.
If you set a password entry using the BIOS setup utility, the password entry screen
appears upon successful completion of POST.
IMPORTANT:
7.
The OS starts when POST completes.

POST Error Messages

When POST detects an error, it displays an error message on the display unit screen or emits beep
code. See Chapter 8 for POST error codes.
IMPORTANT:
consulting with your sales agent. Alarm messages are useful
information for maintenance.
Do not set a password before installing an OS.
Take a note on the messages displayed before