System Connections In passive mode the Stasys 4 use's pins +1 and -1 for it's input. In active mode pins +1 and -1 are connected to the woofer and pins +2 and -2 are connected to the HF driver. The switch to change operating modes can be found above the input speakons on the rear connector panel.
Failure to do so could delay the repair of your product. Warranty Registration Please take time to fill out the warranty registration form at the back of this manual and return it to Void Acoustics. Environmental WEEE Mark If you want to dispose of this product, do not mix with general household waste.
Authorised Void Dealer) that it is free of defects in materials and workmanship and that each product will meet or exceed all factory published specifications for each respective model. Void agrees to repair or replace (at its discretion) all defective parts at no charge for labour or materials; subject to following provisions:...
Page 8
Void Acoustics Unit 10B Dawkins Road Ind Est Poole Dorset BH15 4JD...
Need help?
Do you have a question about the STASYS 4 and is the answer not in the manual?
Questions and answers