Filling The Engine With Oil - Toro Power Clear 621 QZR Operator's Manual

2
Installing the Discharge Chute
Parts needed for this procedure:
3 Screws
1 Chute assembly
Procedure
Install the discharge chute as shown (Figure 7).
1. Discharge chute
Note: For easier installation, use a small ratchet wrench to
tighten the screws.
Important: Do not overtighten the screws; otherwise
you may damage the discharge chute and prevent it
from turning freely.
3

Filling the Engine with Oil

No Parts Required
Procedure
Your machine does not come with oil in the engine, but it
does come with a bottle of oil.
Important: Before starting the engine, fill the engine
with oil.
Note: The bottle of oil may contain an ounce or two more
than the engine requires. Do not overfill or under fill the
engine.
Figure 7
2. Screw (3)
Max fill: 20 oz. (0.6 l), type: automotive detergent oil with an
API service classification of SJ, SL, or higher.
Use Figure 8 below to select the best oil viscosity for the
outdoor temperature range expected:
1. Move the machine to a level surface.
2. Clean around the oil fill cap (Figure 9).
1. Oil fill cap
3. Unscrew the oil fill cap and remove it.
4. With the machine in the operating position, carefully
pour oil into the crankcase. Wait 3 minutes for the oil
to settle and add enough to bring it to the point of
overflow. There should be very little, if any, oil left in
the bottle.
Note: You may tip the machine forward (handle up)
to make adding oil easier. Remember to return the
machine to the operating position before checking the
oil level.
Important: Do not tip the machine all the way
forward onto its nose, or fuel may leak out of the
machine.
5. Screw the oil fill cap into the oil fill hole and tighten it
securely.
6
Figure 8
Figure 9