13.6. While rotating the control hub forward the lapbar
control rod can be disconnected and removed.
See Figure 13.6.
Figure 13.6
13.7. Pull the control hub off the control shaft.
See Figure 13.7.
Control shaft
Reverse safety switch
Figure 13.7
13.8. Remove outboard hex flange bearing. Inspect
and replace as needed.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Hair pins
Lap bar control rod
13.9. The control shaft can be removed from under-
neath the seat frame box. See Figure 13.9.
Brake switch
Figure 13.9
13.10. Inspect hex flange bearing and control shaft.
Replace as needed.
NOTE: Applying anti-seize compound to the
double "D" end of the control shaft will aid in
future removal of the shaft.
NOTE: Undertaking the "DECK REMOVAL"
section of this manual will make this procedure a
little less painful but, is not necessary.
16
Control shaft