Control Shaft Replacement - Cub Cadet RZT Zero Turn 17 Service Manual

12.6. Remove the left console as described in the
"CONSOLE REMOVAL" section of this manual.
12.7. Rotate tank upward and slide out toward the
side. See Figure 12.7.
Figure 12.7
12.8. Disconnect the fuel line from the fuel pump and
carefully remove fuel tank from unit.
NOTE: Make sure to clean up any spilled fuel.
NOTE: During reassembly be certain to recon-
nect electrical connector and fuel line.
NOTE: This would a good time to change the
fuel filter.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Fuel tank
13.

CONTROL SHAFT REPLACEMENT

13.1. Disconnect the - (negative) lead to the battery.
13.2. Remove appropriate side console. refer to
"CONSOLE REMOVAL" section of this manual.
13.3. Disconnect the ferrule from the return to neutral
assembly. See Figure 13.3.
Control arm
Figure 13.3
13.4. Remove hex head cap screw and flat washer
securing the control hub to the control shaft.
See Figure 13.4.
Figure 13.4
13.5. Remove hair pin securing the lapbar control rod
to the control hub.
15
Control hub