Route - Huawei ADSL2+Broadband Router Aolynk DR814 User Manual

User Manual
Aolynk DR811/DR814 ADSL2+Broadband Router
Click LAN Setup in the Main menu and choose the DHCP tab in the Main Frame to
open the DHCP configuration page.
Figure 4-9 DHCP setting
This page allows you to:
Enable/disable the DHCP server.
l
Assign the DHCP server address pool.
l
If the DHCP server is currently disabled, you may click the
If the DHCP server is currently enabled, you may click the
it.
The DHCP server (if enabled) will use the address pool defined in this page to provide
IP addresses to requesting DHCP clients. You may check the Use the default range
box to assign a suitable default IP address pool on this subnet (recommended). If
needed, you can change the DHCP address pool manually, but you must uncheck the
Use the default range box in the meantime.
To change the DHCP address pool manually, enter the start IP address and/or end IP
address, and then click the
IP Addresses.
Enter a DNS suffix in the Local domain name box as needed. This option is usually
used for small- to moderate-sized enterprises. Common home users do not need to set
it.

4.6 Route

This option allows you to create static IP routes to destination addresses via an IP
interface name or a gateway address.
To access the route configuration page, follow anyone of these steps:
button. For more details about IP address, refer to 6.1
22
4 Web-based Management
button to enable it.
button to disable