Using The Device; Powering The Device On/Off; Selecting The Input Source - Silvercrest LT 710 User Manual And Service Information

English

Using the Device

Powering the Device On/Off

Place the On/Off button (1) on the side panel must be put in ON position.
The device will power on in the last-used mode (DTV, TV or AV) and the
status indicator (7) will light green.
To power the device off at any time, press the button (14) on the remote
control. Then the device will enter Standby mode and the status indicator (7)
will light red. It is also possible to power the device back on from Standby
mode by pressing the button (14) on the remote control again.
To power the device off completely, place the On/Off button (1) on the side
panel in OFF position.
After the device has been powered off by using the On/Off
button (1) on the side panel it cannot be powered on via the
remote control.

Selecting the Input Source

Depending on the antenna or the external device that you have connected
you have to select the corresponding input source. To do so, press the
button DTV/ATV/AV (34) on the front of the device or the button
DTV/ATV/AV (15) on the remote control.
Each press of the button will toggle the input source cyclically to the next
available value.
14
SilverCrest LT 710