Connecting External Devices And Antennae; Terrestrial Analogue Reception; Terrestrial Digital Reception; External Devices - Silvercrest LT 710 User Manual And Service Information

SilverCrest LT 710 English

Connecting External Devices and Antennae

This DVB-T receiver allows you to receive terrestrial digital and analogue
stations. Furthermore, the device has an input receptacle for connecting an
external signal source.
If you want to use your LT 710 to watch analogue TV from a cable box or
outdoors antenna, picture and/or sound interference may occur because of
the high sensitivity of the tuner. In such a case, please connect an attenuator
in the antenna cable and reduce the antenna signal level until the picture
and/or sound interference has disappeared. But do not exceed attenuating,
as otherwise noise may occur.

Terrestrial Analogue Reception

Input source: TV
You can use the supplied telescopic antenna for receiving any terrestrial
analogue stations. If any, you can also connect the device to an existing
outdoors antenna or cable TV box. Plug the antenna cable into the antenna
receptacle (3) on the side panel of the device. When using the supplied
telescopic antenna, extend it fully.

Terrestrial Digital Reception

Input source: DTV
You can use the supplied telescopic antenna for receiving any terrestrial
digital stations. If any, you can also connect the device to an existing
outdoors antenna. Plug the antenna cable into the antenna receptacle (3) on
the side panel of the device. When using the supplied telescopic antenna,
extend it fully.

External Devices

Input source: AV
To connect an external device, this has to have an audio and video (AV)
output. Connect the video cable (normally yellow) to the video input
receptacle (4) on the device's side panel. Connect the audio cables (normally
red and white) to the corresponding coloured input receptacles (5) on the
device's side panel. Also follow the operating instructions of your external
device.
13