Table of Contents
Advertisement
Canopy T1/E1 Multiplexer
Desired Action
Desired Action
Get FPGA Revision
4.2
REGULATORY COMPLIANCE INFORMATION
This section contains information regarding regulatory compliance with the Federal
Communication Commission, Department of Communications and the European
Telecommunications Standards Institute applies to the Canopy BH radio link.
4.2.1
Federal Communication Commission Declaration of Conformity Statement
This device complies with Part 15 of FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and radiates radio-frequency
energy, and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
WARNING!
The Part 15 radio device operates on a non-interference basis with the
other devices operating at this frequency. Any changes or modification to
said product not expressly approved by Motorola Canopy could void the
user's authority to operate this device.
Issue 1
Syntax, Response, and Description
Syntax, Response, and Description
Enter get fpga revision
The system responds
FPGA
revision is: x.y.z
Get the revision (version number) of the Canopy T1/E1 FPGA. The
FPGA controls the T1 parameters.
T1/E1 Multiplexer Release 3.1
June 2004
67 of 69
Page
Advertisement
Table of Contents
