Canopy T1/E1 Multiplexer
1.2.1
Ethernet Interface
The Ethernet physical layer auto-negotiation should be set to on for both sides of the
Canopy T1/E1 Multiplexer.
RJ-45 connector pin-outs for the Ethernet cable from the BH to the Canopy port of the
Canopy T1/E1 Multiplexer are illustrated in
1.2.2
Standards
The Canopy T1/E1 Multiplexer conforms to the following standards:
◦
G.703
◦
G.823
◦
G.824
◦
ANSI T1.403
1.2.3
IDU Physical Description
The unit provides a compact, simple to configure, and easily scalable solution for
transporting T1/E1 services over Canopy's wireless Ethernet-based networks.
1.2.4
Rear Panel
Interface connections and the power port are located on the rear panel of the unit.
Issue 1
◦
◦
◦
Figure 3: Canopy T1/E1 Multiplexer rear panel
T1/E1 Multiplexer Release 3.1
Figure 13
on Page 28.
TR-AT&TG2411
IEEE 802.3
EMC Class A compliance – EN 55022 Class A
June 2004
11 of 69
Page