Table of Contents
Advertisement
PRODUCTION LOCK MORTISING
If you have a number of doors with the locks at the same height, the height
rod attachment (see Fig. 11) will be of great value. After you have determined
the height you want, and have the lock mortiser in position on the first door,
assemble the four rods that compose the height rod attachment. Insert the
rods in the mortiser and place the height rod stop (G) on the top of the rod so
it rests on the top of the door. Lock the height rod screws, (H) Fig. 11A. To
locate the mortiser on the next door, simply place the mortiser on the door
with the height rod stop resting on the top of the door and tighten the
clamps. This will assure having all locks located in the same position.
G
Fig. 11
MODEL 517 LOCK FACE TEMPLET
REQUIRED EQUIPMENT
Equipment required for use with Router and Lock Face Templet.
42024 Templet Guide (included)
42237 Locknut (Included)
43440PC
5
" (15.9 mm) Diameter Straight Bit (not included)
/
8
SETTING UP TEMPLET
1.
Loosen locking screw (A), Fig. 12.
2.
Adjust side guides (C), Fig. 12, so the space between them is
(3.2 mm) wider than the lock face.
3.
Firmly tighten screw (A).
4.
Loosen locking screw (D), Fig. 12.
5.
Adjust guide bar (E), Fig. 12, distance between (E) and (B) is
1
" (3.2 mm) longer than the lock face.
/
8
6. Firmly tighten screw (D).
Fig. 11A
13
H
1
"
/
8
Advertisement
Table of Contents
