Table of Contents
Advertisement
A p p l i c a t i o n s
time to save power; press
again. You can prevent the compass from going into standby
mode by pressing a number key every few minutes.
You can use the flashlight when the compass is active.
Calibrating the compass
1. Press Menu, and select
2. If the phone requests you to calibrate the compass,
must be calibrated first
and select Calibration.
3. To start the calibration, press Yes. Place the phone on a
horizontal, level surface, and carefully rotate it; or, while
holding it horizontally, slowly turn it around. Use the
rotating graphic on the display to observe the speed of
rotation. When the calibration is finished,
appears.
Setting the declination
1. Press Menu, and select
2. Press Options, and select
declination
to set the declination.
To activate the last set declination value, select On.
3. Key in the declination value in degrees from 0 to 180, and
press OK.
4. Select the direction of the declination:
Setting and resetting the direction
1. Press Menu, and select
2. To reset the direction of the intended destination, press
Reset
and Yes. Point the phone in the direction of the
intended destination, and press
3. The arrow points in the direction you have set, and the
numeric value is shown at the top right of the display. When
the arrow points up on the display, the phone is pointed in
the correct direction.
Continue
to activate the compass
→
Applications
is shown. Otherwise, press Options,
→
Applications
→
Settings
Declination
→
Applications
Set
direc..
92
→ Compass.
Extras
Compass
Compass calibrated
→ Compass.
Extras
→
Set
East
(+)
orWest
→ Compass.
Extras
(-).
Advertisement
Table of Contents
