Auto Reconnect Mode
Auto Reconnect controls whether or not the scanner automatically begins
the relink process when a loss of connection is detected. When the Auto
Reconnect On bar code is scanned, the scanner begins the relink process
immediately, without user intervention. Default = Auto Reconnect On.
* Auto Reconnect On
The following table shows the results of the Auto Reconnect On and Off
settings:
Event
Scanner out of
range
Base reset
(firmware upgrade
or power cycle)
Scanner reset due
to firmware
upgrade
Scanner reset due
to battery change
Scanner placed in
different base unit
Auto Reconnect On
Relink occurs
automatically. If
maximum number of link
attempts is
unsuccessful, then the
scanner must be
relinked by either
pressing the scanner's
button or placing the
scanner in the base.
(See
Maximum Link
Attempts
on page 3-24.)
Scanner behaves as if
out of range.
Relink occurs automatically.
Relink occurs automatically.
Relink to new base occurs automatically.
Auto Reconnect Off
Auto Reconnect Off
The scanner is
relinked by pressing
the button.
No attempt to relink
made while base is
powered off. Button
must be pressed to
initiate relinking.
3 - 23