Monitor Angle Control; Ext Sw Setup; [Ext Sw] - Kenwood DNX9280BT Instruction Manual

Monitor Angle Control

You can adjust the position of the monitor.
1 Display the Angle Setup screen
>
Touch [ ] [
(page 68)
2 Set the Monitor Angle
1
1 Sets the Monitor angle.
[Off Position] Stores the current monitor angle
as the angle during power off.
However, the setting value returns to "0" if you
detach the front panel.
[Auto Open] When turned on, the front panel
is set to open automatically when the ignition
is turned off, so that it can be detached for
antitheft purpose. (

EXT SW Setup

Sets up the exteral switch power mode.
1 Display the EXT SW screen
>
Touch [ ] [
(page 68)
2 Perform EXT SW Setup
> >
] [Display] [Angle].
"OFF")
> >
] [System]

[EXT SW].

[SW1 Name]/ [SW2 Name] Sets the name of the
external device. See
Entry Screen> (page 73)
enter a name.
[Output Pattern] Sets the power signal output
mode.
( EXT SW1: Pulse, EXT SW2: Level)
"Pulse": Generates a single power signal pulse.
"Level": Continues output of high power signal.
Sets to turn output on/off each time the button
on the EXT SW Control screen is touched. See
<External Device Power Supply Control> (page
46).
[Pulse Set] Sets the Pulse signal output time.
Outputs 500ms when "1" is set. Increases by
200ms with each step. Up to 100 steps can be
set.
How To Use the Character Entry Screen
1 Enters characters.
[2], [3] Shifts the cursor.
[5], [∞] Switches between key layouts.
[Shift] Toggles between uppercase and
lowercase.
[qwe]/ [abc] Sets the key layout of the character
buttons.
abc : Alphabetical key layout.
qwe : Qwerty key layout.
[Clear] Clears the character.
If you erase a character, locate the cursor on it
and touch this button.
[Space] Enters a space.
⁄
• You can enter characters only after you have applied
the parking brake.
<How To Use the Character
for information on how to
1
Next page 3
English
73