Security Setup; Monitor Angle Control; [Ext Sw] - Kenwood DNX9980HD Instruction Manual

Setup Menu

Security Setup

A red indicator will blink on the unit after the ACC
is set to OFF, warning potential thieves.
1 Display the Security screen
>
Touch [ ] [
(page 72)
2 Setup the SI (Security Indicator)
[SI] Turns the SI function on or off.
If turned "ON", the security indicator on the front
panel flashes when the vehicle ignition is off.
( "ON")

Monitor Angle Control

You can adjust the position of the monitor.
1 Display the Angle Setup screen
>
Touch [ ] [
(page 72)
2 Set the Monitor Angle
1
1 Sets the Monitor angle.
[Off Position] Stores the current monitor angle
as the angle during power off.
76
DNX9980HD
> >
] [System] [Security].
> >
] [Display] [Angle].
EXT SW Setup
Sets up the exteral switch power mode.
1 Display the EXT SW screen
>
Touch [ ] [
(page 72)
2 Perform EXT SW Setup
[SW1 Name]/ [SW2 Name] Sets the name of the
external device. See
Entry Screen> (page 77)
enter a name.
[Output Pattern] Sets the power signal output
mode.
( EXT SW1: Pulse, EXT SW2: Level)
"Pulse": Generates a single power signal pulse.
"Level": Continues output of high power signal.
Sets to turn output on/off each time the button
on the EXT SW Control screen is touched. See
<External Device Power Supply Control> (page
50).
[Pulse Set] Sets the Pulse signal output time.
Outputs 500ms when "1" is set. Increases by
200ms with each step. Up to 100 steps can be
set.
> >
] [System]

[EXT SW].

<How To Use the Character
for information on how to