Cub Cadet Z-Force 54-KH Operator's Manual page 24

Battery Maintenance
• The battery is filled with battery acid and then sealed at the
factory. However, if the battery is equipped with fill caps,
remove them and check the level of the liquid electrolyte
in the battery every 50 operating hours. If the level in any
of the six cells has dropped below the bottom of the split
ring inside the fill hole, refill the cell with distilled water.
• Spray the terminals and exposed wire with a battery
terminal sealer, or coat the terminals with a thin coat of
grease or petroleum jelly, to protect against corrosion.
• Always keep the battery cables and terminals clean and
free of corrosion.
• Avoid tipping. Even a sealed battery will leak electrolyte
when tipped.
WARNING!
emit explosive gases. Use extreme caution when
handling batteries. Keep batteries out of the reach
of children.
Tire Maintenance
Check the tire air pressure before each use. Inflation pressure
of the rear tires is important for stability while the mower is in
operation. If the tire diameter is not equal between the two tires,
the mower will pull to one side. Keep the tires inflated to the
recommended pressures. Improper inflation will shorten the tire
service life. See the tire side wall for proper inflation pressures.
Observe the following guidelines:
• Do not inflate a tire above the maximum pressure shown
on the sidewall of the tire.
• Do not reinflate a tire that has been run flat or seriously
under inflated. Have a qualified tire mechanic inspect and
service the tire.
• Balance inflation pressure between the rear tires to help
maintain straight travel (see tire side wall for proper
inflation pressure).
• Keep the valve caps tightened to prevent air pressure loss.
Lubrication
• Using a pressure lubricating gun, lubricate all grease
fittings and points as noted in the Lubrication Chart.
• Lubricate all other pivot points with a quality lubricating oil
as noted in the Oil Chart.
Using the Deck Wash System
WARNING!
never engage the deck from any position other than
the operator's seat of the tractor. Do not use an
assistant or engage deck in the presence of any
bystanders.
Use the Deck Wash System to rinse grass clippings from the
deck's underside and prevent the buildup of corrosive chemicals.
Complete the following steps after each mowing:
NOTE: Make certain the machine's discharge chute is directed
away from people, children, animals, and your house, garage,
parked cars, etc.
1. Attach the nozzle adapter to a standard garden hose
24 s 6— M
ectiOn aintenance
Batteries contain sulfuric acid and may
When using the deck wash system,
& a
djustMents
connected to a water supply.
2. Move the tractor to an area within reach of the hose where
the dispersal of wet grass clippings is not objectionable to
you. Disengage the PTO, engage the parking brake, and
stop the engine.
3. Pull back the lock collar of the nozzle adapter and push the
adapter onto one of the deck wash nozzles at either end of
the mower deck. Release the lock collar to lock the adapter
on the nozzle. See Fig. 6-2.
Pull Lock
Collar Back
Nozzle
Adapter
Adapter
Lock Collar
Deck Wash Nozzle
Figure 6-2
4. Turn on the water supply.
5. From the tractor operator's seat, start the engine and
engage the PTO. Allow to run as needed. Disengage the
PTO and stop the engine.
6. Turn off the water supply.
7. Pull back the lock collar of the nozzle adapter to disconnect
the adapter from the nozzle.
8. Repeat the previous steps to clean the deck using the
nozzle at the other end of the deck.
Cleaning the Spindle Pulleys
Once a month remove the belt covers to remove any
accumulation of grass clippings from around the spindle pulleys
and V-belt. Clean more often when mowing tall, dry grass.