Change The Mode Of The Registered Projector; Status - Sanyo PLV-80 Series Owner's Manual

Change the mode of the registered projector

To change the mode of the registered projector, select a mode with the pull-down menu
button under the IP address of the target projector and then click

Status

If some of the registered projectors are disabled by
some reasons (such as disconnecting the power source,
disconnecting the LAN cable, disconnecting from the
network), control changes will continue to be effective
for the projectors that are still active. At the same time,
the deactivated projectors are excluded from the multi-
control. The status of the registered projectors are indi-
cated under the projector name. See the table below
for status indications.
Status Description
(blank) .................... The projector is connected to the network correctly
No connect .............. The projector may not be connected to the network. Please check the connection
and network configuration of this projector.
PIN code error ....... The PIN code is incorrect. The PIN code for the multi-controlled projectors must be
the same. Change the PIN code of this projector to the common PIN code. (+p.22)
* The Network Unit updates the status at the time when the multi-control function was executed.
✐ If the multi-controlled projector is in the standby mode, any change is not effective except timer
setting.
✐ It is recommended that a specified projector should be chosen for setting as a master when you
use this multi-control function. The control for the multi-controlled projectors will become too
complicated operation if this function is used for each projector.
✐ If the registered projector is not connected to the network, it will take some time to complete the
multi-control operation because of waiting for the response from each registered projector.
Mode Operation
........................ Multi-controlling the projector
Control
............................. Excluding from the multi-control
OFF
.......................... Deleting from the multi-control
Delete
* This function is not available with the Light mode.
Multi-control
button.
Set
Status
PJ-NET ORGANIZER
OWNER'S MANUAL [PLV-80/75 Series]
1