Replacing The Integrated Camera - Lenovo ThinkCentre M83z Maintenance Manual

10. To install the new system fan, position the new system fan in the chassis so that the two screw holes in
the new system fan align with the corresponding holes in the chassis. Then, install the two screws to
secure the system fan to the chassis.
11. Route the cable of the new system fan, and then connect the cable to the system board. See "Locating
parts on the system board" on page 71.
12. Install the VESA mount bracket. See "Removing and installing the VESA mount bracket" on page 94.
13. Install the rear I/O assembly. See "Replacing the rear I/O assembly" on page 87.
14. Install the system-board shield. See "Removing and installing the system-board shield" on page 86.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 119.

Replacing the integrated camera

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Safety information" on page 1.
This section provides instructions on how to replace the integrated camera.
Note: The integrated camera is available only in some models.
To replace the integrated camera, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or other flat surface. Hold the sides of your computer and
gently lay it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer stand. See "Removing and installing the computer stand" on page 73.
4. Remove the computer cover. See "Removing the computer cover" on page 76.
98
ThinkCentre M83z Hardware Maintenance Manual