Troubleshooting; In Case Of Difficulty - Honeywell FOCUSPRO TH5000 Operating Manual
Focuspro th5000 series non-programmable digital thermostat
Hide thumbs
Also See for FOCUSPRO TH5000:
- Installation manual (25 pages) ,
- Operating manual (19 pages) ,
- Installation manual (17 pages)
Table of Contents
Advertisement
Available languages
Available languages
In case of difficulty
If you have difficulty with your thermostat, please try the following suggestions.
Most problems can be corrected quickly and easily.
Display is blank
Temperature
Make sure heating and cooling temperatures are set to acceptable ranges:
settings do not
change
• Check circuit breaker and reset if necessary.
• Make sure power switch at heating & cooling system is on.
• Make sure furnace door is closed securely.
• If thermostat is battery-powered, make sure fresh AA or AAA alkaline
batteries (depending on model) are correctly installed (see page 10).
• Heat: 40° to 90°F (4.5° to 32°C).
• Cool: 50° to 99°F (10° to 37°C).
11
FocusPRO
TH5000 Series
®
69-1923EFS—01
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the FOCUSPRO TH5000 and is the answer not in the manual?
Questions and answers
When you press and hold the **** button and up button you get a dlay with a number on left and one on right, what should these numbers be set at bc mine when on main screen shows 8.5° on left and 24° on right, how do i get it to show the true temp settings again
I have a honeywell thermostat th5320u1001 and want to wire it to operate a gas boiler. which wires do i use andvdo i set a delayin the programming
The Honeywell FOCUSPRO TH5000 thermostat supports gas heating systems, including boilers. When wiring the thermostat to a gas boiler, follow these steps:
1. Turn Off Power: Shut off power to the heating system to avoid electrical hazards.
2. Identify Wires: Locate the existing thermostat wires and identify their terminals.
3. Connect Wires:
- R (Power, 24V) → Connect to the R terminal (If there is an RH and RC terminal, use a jumper wire).
- W (Heating) → Connect to the W terminal.
- C (Common, if available) → Connect to the C terminal for continuous power.
4. Secure Connections: Ensure all wires are properly secured in their terminals.
5. Mount Thermostat: Attach the thermostat to the wallplate and restore power.
Regarding a delay setting, the thermostat includes a built-in compressor protection delay of 5 minutes to prevent short-cycling. Since gas boilers typically do not require compressor protection, this delay is not necessary for heating operation. However, if using a heat pump in addition to the boiler, the delay should remain enabled.
This answer is automatically generated