HP xw4600 Service And Technical Reference Manual page 78

2. If necessary, unlatch the plastic snap that secures the cables inside the chassis (1), and then
disconnect the front panel I/O device assembly cables from the system board (2).
Figure 4-13
3. Remove the two smaller Torx screws (1) that hold the front panel I/O device assembly and bracket
to the chassis (3).
Figure 4-14
4. Remove the two larger Torx screws (2) that hold the front panel I/O device assembly to the bracket
(3).
5. Separate the bracket from the front panel I/O device assembly.
6. Pull the front panel I/O device assembly out about two inches from the chassis (5).
7. Pull the front panel cables through the chassis and through the front of the workstation. You might
have to slide the cables out one at a time.
70 Chapter 4 Removal and replacement procedures
Removing front panel I/O device cables
Removing the front panel I/O device assembly
ENWW