HP xw4600 Service And Technical Reference Manual page 41

Table 3-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading
Power
Advanced**
ENWW
Option
Virtualization Technology Directed
OS Management of Embedded Security Device—Enables or disables the ability of the operating
system to control the TPM device, including turning it on and off, initializing it, and resetting it.
Reset of Embedded Security Device through OS—Enables or disables the ability of the operating
system to reset the TPM.
Setup Security Enables the administrator to selectively set the security level for each setup feature. The options
Level are: Setup Password and None. Browser mode must be enabled to use this option.
OS Power Enables or disables:
Management
● Runtime Power Management
● ACPI S3 Hard Disk Reset
● ACPI S3 PS 2 Mouse Wakeup
● USB Wake on Device Insertion
● Unique Sleep State Blink Rates
Hardware Power Enables or disables SATA Power Management
Management
Thermal Enables you set the rate of the system fan when the processor is in idle.
Power-On Allows you to set:
Options
●
POST Mode (QuickBoot, FullBoot, or FullBoot every 1–30 days).
●
POST Messages (Enable or Disable).
●
F9 Prompt (Enable or Disable). Enabling this feature displays F9=Boot Menu during POST.
Disabling this feature prevents the text from being displayed. However, pressing the F9 key
still accesses the boot menu.
● F10 Prompt (Enable or Disable)—Enabling this feature displays F10=Setup during POST.
Disabling this feature prevents the text from being displayed, but pressing F10 still accesses
the Setup screen.
●
F11 Prompt (Enable or Disable)—Makes the Factory Recovery option visible during POST.
Disabling this feature prevents the text from being displayed, but pressing F10 still accesses
the Setup screen. Factory Recovery Boot Support must be enabled to use this option.
● F12 Prompt (Enable or Disable)—Enabling this feature displays F12=Network Service Boot
during POST. Disabling this feature prevents the text from being displayed but pressing F12
still forces the system to attempt booting from the network.
●
Factory Recovery Boot Support (Enable or Disable)—Recovery partition hard disk drive
(HDD) option available. Vista leaves the factory with this support in place.
● Option ROM prompt* (Enable or Disable)—Enabling this feature causes the system to display
a message before loading options ROMs.
●
Remote Wakeup Boot Source
● After Power Loss (On or Off)—Enabling this option directs the previous state to be the default.
● POST Delay (in seconds) (Enable or Disable)—Enabling this feature adds a user-specified
delay to the POST process. This delay is sometimes needed for hard drives on some PCI
cards that spin up slowly (so slowly that they are not ready to boot by the time POST is
Description
Computer Setup (F10) Utility 33