Download Print this page
Orbit 57932 Manual

Orbit 57932 Manual

Touch-screen timer

Advertisement

NOTICE: This .pdf file should not
be used as the source to create
final, printed pieces of the file it
represents. Rather, it is a low
resolution visual reference only
containing relevant information
regarding the file (e.g., color, text
and image placement, etc.)

Advertisement

loading
Need help?

Need help?

Do you have a question about the 57932 and is the answer not in the manual?

Questions and answers

Summary of Contents for Orbit 57932

  • Page 1 NOTICE: This .pdf file should not be used as the source to create final, printed pieces of the file it represents. Rather, it is a low resolution visual reference only containing relevant information regarding the file (e.g., color, text and image placement, etc.)
  • Page 2 TOUCH-SCREEN TIMER MANUAL RAIN SENSOR SYSTEM ACTIVE | BYPASS RF SYNC RESET MODELS: 57932, 57936, 57942, 57946, 91832, 91836, 91842, 91846, 94832, 94836, 94842, 94846 PN 57932-24 Rev E 07WTM004225 57932-24 rE.indd 1 5/2/07 4:39:22 PM dimensions: Printers are proof no: flat: w: 13.76"...
  • Page 3: Table Of Contents

    Section 1: Introduction ENGLISH Thank you for selecting the Orbit ® Touch-Screen Timer. Our • Introduction ........2 designers have combined the simplicity of touch-screen •...
  • Page 4 The timer’ s back-lit, touch-screen LCD display screen is conveniently programmed and easy to read under any lighting conditions. You may use either your finger or the built-in stylus on the touch screen. (See Figure 1) 07WTM004225 57932-24 rE.indd 3 5/2/07 4:39:22 PM...
  • Page 5: Getting Started

    In Active position the controller will monitor the rain sensor, in Bypass position the controller will ignore the rain sensor. (This switch is for hard wired sensors only and does not effect wireless rain sensors). 07WTM004225 57932-24 rE.indd 4 5/2/07 4:39:23 PM...
  • Page 6: Programing Your Timer

    If you wish to go back and change any of the settings, press BACK. If not, press ENTER. This will accept the programming and take you to Figure 3: Set Start Times the HOME/AUTO screen. 07WTM004225 57932-24 rE.indd 5 5/2/07 4:39:23 PM...
  • Page 7 • Repeat this procedure for the other program, if desired. using and the Quick Touch buttons. Select the desired stations and durations then press ENTER. • Or, press NEXT again for MANUAL - PROG A watering. This 07WTM004225 57932-24 rE.indd 6 5/2/07 4:39:23 PM...
  • Page 8 START. To cancel the RAIN DELAY and return This timer can communicate with Orbit wireless sensors. to AUTO mode press CANCEL. To change the communication status between the timer and the •...
  • Page 9: Remote Control Device

    RF sensor (the red light should start blinking). ON “X” MIN to water those stations for the desired (“X”) number of minutes. • If the red light blinks you have successfully synchronized the 07WTM004225 57932-24 rE.indd 8 5/2/07 4:39:24 PM...
  • Page 10: Installing The Orbit ® Touch-Screen Timer And Remote Control Device Sleeve

    • In a dry, indoor location, where operating temperatures SENSOR PUMP 24 VAC are not below 32° or above 122° Fahrenheit (below 0 degrees or above 50 degrees Celsius). Figure 5: Mounting the Docking Port 07WTM004225 57932-24 rE.indd 9 5/2/07 4:39:25 PM...
  • Page 11 • Find the two sockets at the bottom of the docking port NOTE: If the distance between the sprinkler timer and valves labeled “24VAC.” (See Figure 6) is under 700’ (210 m), use Orbit ® sprinkler wire or 20 gauge (AWG) plastic jacketed thermostat wire to connect the sprinkler •...
  • Page 12 • Slide the remote control device into the sleeve. than two common wires are required, splice several together so only one wire runs into each of the two “COM” terminals. Protect the splice connection with a wire nut. 07WTM004225 57932-24 rE.indd 11 5/2/07 4:39:26 PM...
  • Page 13: Diagnostics Circuit Breaker

    2. Test the station by operating a manual watering sequence. 3. If the short is not detected after a few seconds, the fault notification message will be terminated. 4. If the message continues, a short in the wiring still exists. 07WTM004225 57932-24 rE.indd 12 5/2/07 4:39:26 PM...
  • Page 14: Glossary Of Terms

    See “Program (A or B)” Watering Valve Used in conjunction with sprinkler timers – a device used to control the delivery of water to lawns, plants and (Irrigation Valve) gardens Zones See “Station (Watering Station)” 07WTM004225 57932-24 rE.indd 13 5/2/07 4:39:27 PM...
  • Page 15 15 min Front, North Spray Heads Grass Odd/Even Every other day 6:45 AM 30 min Back, North Gear Drive Grass Interval Every 5 days 9:00 PM 30 min Front Shrub Head Shrubs and Flowers 07WTM004225 57932-24 rE.indd 14 5/2/07 4:39:27 PM...
  • Page 16: Trouble Shooting

    2. Excessive pressure 3. Stations are set to water with both programs. 4. Water Budgeting is set to more than 100% Persistant Fault 1. Short in wiring or solenoids 07WTM004225 57932-24 rE.indd 15 5/2/07 4:39:28 PM...
  • Page 17 Help for help. Models 57932, 57936, 57942, 57946, 91832, 91836, 91842, 91846, 94832, 94836, 94842, 94846. Before returning this sprinkler timer to the store, contact Orbit ® Technical Service at: Orbit ® Irrigation Limited Six-Year Warranty 1-800-488-6156, 1-801-299-5555. Orbit ®...