The Procedure Of Changing Firmware For Mag200; Basic Software Upgrade Stages On The Device - Infomir MAG-00 User Manual

The procedure of changing firmware for MAG200

1. Prepare all the files required. Proceed as follows
•
Visit http://iptv.infomir.com.ua/fw/upgrade/
•
Load the files Bootstrap, imageupdate and mcast.exe to the same folder
2. Start mcast.exe. The Windows may ask you to install Microsoft .Net Framework
Version 2.0 Redistributable Package first. Install this application (see
to operating system») and then run mcast.exe again.
3. After starting mcast.exe select network interface through which the files Bootstrap and
imageupdate will be broadcast.
4. If the files Bootstrap and imageupdate are stored in the same folder with mcast.exe,
you can go to the step 5. Otherwise, you will have to specify the path to these files in
the main form of the application. The path to the file Bootstrap is set in the field «File
name» of the section «Stream 1». Use the button «Select file» or enter the path
manually. Similarly set the path to the file imageupdate in the section «Stream 2».
The values of other settings can retain default values.
5. Start broadcasting both streams by press the button «Start» in both sections.
6. Enter bootstrap loader menu of the device. Proceed as follows:
•
Turn off the device using the switch on its rear panel.
•
Press and keep the button «menu» on the remote control or the button
«On/Off» on the front panel.
•
Turn on the device and continue keeping the «menu» button until the
bootstrap loader menu appears on the screen (within 2–3 seconds).
•
After the menu appears on the screen release the button.
7. Select menu item «Upgrade Tools» (« » button) and then «MC Upgrade» (« »
again). If everything was performed correctly the device goes to the mode of basic
software automatic upgrade.

Basic software upgrade stages on the device

•
Starting the device in «DHCP» mode.
•
Bootstrap loading from a multicast group or fttp.
•
Checking Bootstrap digital signature.
•
Starting Bootstrap. Further process of loading the software image by the Bootstrap
is accompanied with displaying corresponding messages on the TV screen. Initial
screen after starting Bootstrap is:
MAG-200. User Guide
42
(Rev 1.2 05/02/2010,17:23)
«Requirements