Do you have a question about the MAG544 and is the answer not in the manual?
Questions and answers
Mahesh Shah
January 27, 2025
Does this work on 110V 0r 220v (India)
1 comments:
Mr. Anderson
February 10, 2025
The Infomir MAG544 supports a power supply range of 90–264V AC, which includes both 110V and 220V. Therefore, it will work in India, where the standard voltage is 220V.
This answer is automatically generated
Daniel
January 28, 2025
How do I turn subtitles on?
Jorge A Bergia
February 2, 2025
how do I get the actual operating manual ... Not the installation instuctions for the MAG 544 W3... I mean how to operate it... and the use of each of the buttons, select and chanels... save them and delete them from the "FAVORITES" ETC.
1 comments:
Satya Arya
February 10, 2025
@Jorge A Bergia
Rene
February 7, 2025
How can I make a favorite list with my favorite TV stationsRene
Narendra
February 10, 2025
Box need on every time
1 comments:
Mr. Anderson
February 11, 2025
No, the Infomir MAG544 does not require a box to operate every time. It can play content stably from external media and NAS servers, allowing it to function offline without needing constant access to an external service or box.
This answer is automatically generated
Nabad B.
March 18, 2025
how do i connect Bluetooth headphones or ear bud. The settings does not have an option (Network>Bluetooth )
1 comments:
Mr. Anderson
March 18, 2025
The Infomir MAG544 does not have built-in Bluetooth support. If there is no Bluetooth option in the settings, you can use an external Bluetooth transmitter. Connect the transmitter to the device's audio output (such as the headphone jack or RCA audio output) to enable wireless audio transmission to Bluetooth headphones.
This answer is automatically generated
Prashant Patel
March 21, 2025
My Mag544w3 remote is not connected to box even after installing fresh new battery.
1 comments:
Mr. Anderson
March 21, 2025
The Infomir MAG544 remote may not be connecting to the box after installing a new battery due to the following reasons:
1. Battery Installation: Ensure the two AAA batteries (R03, LR03, UM-4, 286) are correctly installed with the correct polarity. 2. Idle Mode Reset: The remote may need a reset. Press and hold the “SETUP” and “OK” buttons simultaneously while the remote is in idle mode. 3. Interference or Obstruction: Check for any obstructions between the remote and the set-top box that may block the signal. 4. Remote Control Copying Process: If using a copied or alternative remote, ensure the copying process is completed by pressing the “OK” button on the STB remote until both LEDs double blink and turn off. 5. Defective Remote or STB Sensor: If none of the above work, the remote or the STB’s IR sensor could be defective.
EU declaration of conformity is available at the following 1) this device may not cause harmful interference, and internet address: www.infomir.eu/eng/support/declarations 2) this device must accept any interference received, including This device is certified for indoor deployment only in the interference that may cause undesired operation.
Warranty CAUTION: Warranty term Unauthorized antennas, modifications, or attachments could Europe, MEASA and Oceania: damage the device and violate FCC regulations. Changes or 2 years from date of sale (but not more than 2,5 years from modifications not expressly approved by responsible party manufacture date).
Page 4
INFORMATION PROVIDED IN THIS INSTRUCTION MANUAL. 60486, Frankfurt am Main, Germany Tel.: +49 6196 204 83 18 Warranty Service Coupon e-mail: warranty@infomir.com The USA, Canada and Latin America: (to be filled in by a shop-assistant) Infomir USA 174 Bay 49...
Warranty conditions The present warranty is only valid if the defective product (2) mounting and maintenance of the product in conditions not corresponding to safety standards and regulations is provided with properly filled in Warranty Service valid in Coupon. If date of sale is not pointed, the warranty term is the country of use;...
Copyrights and Trademarks Notice of Copyright a) You shall not make attempts to change, extend, decompile, Telecommunication Technologies LLC. All rights reserved. disassemble, redesign, or otherwise attempt to access the The Information contained herein is the property software source code, and you not allow third-parties to do of Telecommunication Technologies LLC (the Company).
Copyrights and Trademarks Terms of using Trademarks Safe and Efficient Using Инфомир, Infomir, MAG are the trademarks of Infomir. Device does not contain harmful or hazardous substances. The terms HDMI and HDMI High-Definition Multimedia Accessories Interface, and the HDMI Logo are trademarks or registered Use the accessories supplied with your arrangement or trademarks of HDMI Licensing Administrator, Inc.
Page 8
The Product Unpacking and Installation After the product extraction out of the package it is necessary is not to be laid under the carpets or blocked with anything to handle it with care, do not drop, shake it and afford where any damage may not be noticed.
Product Care Maintenance of Product TV. Any other use is prohibited. It means Telecommunication The product should not be disassembled. The tries of the Technologies LLC insists on the product usage in entirely disassembling of the product may be dangerous for your accordant to the law of copyright.
NOTE: SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE. USB Interface INFOMIR RESERVES THE RIGHT TO REVISE THIS PUBLICATION AND TO Type: USB2.0 × 2 pcs. MAKE CHANGES IN ITS CONTENT FROM TIME TO TIME BY POSTING Supported Audio and Video Formats NEW SPECIFICATIONS AND OTHER CONTENT AT WWW.INFOMIR.EU...
Page 11
About your MAG544, MAG544w3 Front Panel Fn — reset to factory settings/ select the boot mode USB 2.0 USB 2.0 Power On/Standby Back Panel Power Supply 5 V HDMI 2.1 Ethernet LAN port...
Page 12
Connecting to MAG544, MAG544w3 Step 1 Connect HDMI Cable 90–264 V AC Step 2 Step 3 Connect Power Supply Unit Connect to the Internet (via Ethernet or Wi-Fi *) WARNING! SWITCH OFF ALL THE DEVICES (TV, AMPLIFIER, ETC.) AND TAKE THE POWER SUPPLY UNIT OUT OF THE SOCKET BEFORE CONNECTING OR DISCONNECTING ANY CABLE.
Remote Control Reset requires two batteries type AAA, R03, LR03, UM-4, 286. Make sure RC is in idle mode (no IR-transmission or visual The MAG544, MAG544w3 package includes a remote control activity). Press “SETUP” and “OK” buttons at the same...
Page 14
MiniFusion Remote Control power* STB power A/V* Electronic Program Guide Mute* Quick access to IPTV Volume + Volume − Home Refresh Rewind Play / pause Resize Fast forward TV channel selection Keyboard BUTTONS ALLOWED TO STORE COPIED DATA...
Product Information The set includes the following: Set-top box 1 pcs. External power supply 5 V 1 pcs. HDMI cable (length less than 1.5 m) 1 pcs. IR remote control 1 pcs. AAA batteries 2 pcs. Instruction manual 1 pcs. Package box 1 pcs.
Need help?
Do you have a question about the MAG544 and is the answer not in the manual?
Questions and answers
Does this work on 110V 0r 220v (India)
The Infomir MAG544 supports a power supply range of 90–264V AC, which includes both 110V and 220V. Therefore, it will work in India, where the standard voltage is 220V.
This answer is automatically generated
How do I turn subtitles on?
how do I get the actual operating manual ... Not the installation instuctions for the MAG 544 W3... I mean how to operate it... and the use of each of the buttons, select and chanels... save them and delete them from the "FAVORITES" ETC.
@Jorge A Bergia
How can I make a favorite list with my favorite TV stationsRene
Box need on every time
No, the Infomir MAG544 does not require a box to operate every time. It can play content stably from external media and NAS servers, allowing it to function offline without needing constant access to an external service or box.
This answer is automatically generated
how do i connect Bluetooth headphones or ear bud. The settings does not have an option (Network>Bluetooth )
The Infomir MAG544 does not have built-in Bluetooth support. If there is no Bluetooth option in the settings, you can use an external Bluetooth transmitter. Connect the transmitter to the device's audio output (such as the headphone jack or RCA audio output) to enable wireless audio transmission to Bluetooth headphones.
This answer is automatically generated
My Mag544w3 remote is not connected to box even after installing fresh new battery.
The Infomir MAG544 remote may not be connecting to the box after installing a new battery due to the following reasons:
1. Battery Installation: Ensure the two AAA batteries (R03, LR03, UM-4, 286) are correctly installed with the correct polarity.
2. Idle Mode Reset: The remote may need a reset. Press and hold the “SETUP” and “OK” buttons simultaneously while the remote is in idle mode.
3. Interference or Obstruction: Check for any obstructions between the remote and the set-top box that may block the signal.
4. Remote Control Copying Process: If using a copied or alternative remote, ensure the copying process is completed by pressing the “OK” button on the STB remote until both LEDs double blink and turn off.
5. Defective Remote or STB Sensor: If none of the above work, the remote or the STB’s IR sensor could be defective.
Try these steps to troubleshoot the issue.
This answer is automatically generated