JVC KD-NX5000 Instructions Manual page 95

Through: Select when the subwoofer is not connected.
On:
Select when the subwoofer is connected.
Adjust the crossover frequency between the front/rear
speakers and the subwoofer.
55
Hz,
85
Hz,
125
Hz
(Initial setting)
You can change the maximum volume level of this
receiver.
Amplifier Off: Deactivates the built-in amplifier.
Low Power: Volume 00 to 30 (Select this if the maximum
power of the speakers is less than 50 W)
High Power: Volume 00 to 50
Adjust the settings below in the submenu:
• Phase: Subwoofer phase. Select either Normal or
Reverse, which reproduces a better sound.
• Level: Subwoofer output level. 00
to
08 (04)
Adjust and store auto-adjustment volume level for each
source, comparing to the PM volume level. The volume
level will automatically increase or decrease when you
change the source.
-12
to
+12
(00)
Adjust fader-speaker output balance between the front
and rear speakers. (00)
F06: front only
R06: rear only
• When using a two-speaker system, set the fader to the
center (00).
Adjust balance-speaker output balance between the left
and right speakers. (00)
L06: left only
R06: right only
Flat, Hard Rock, R&8, Pop, Jazz, Dance Music,
Country, Reggae, Classic, User 1, User 2,
User 3
~
[981
Selectable settings
AV Menu items
95 . . . .