Final Hardware Check - HP Integrity BL860c i2 User's & Service Manual

d. After the iLO 3 MP reset (less than one minute), log back into the iLO 3 MP, go to the
Command Menu, and enter sysset again to verify that the system information parameters
have been set for correctly for both Primary and Secondary. The values between Primary
and Secondary should now match.
[ilo002264fee1be] CM:hpiLO-> sysset
SYSSET
Current System Information Parameters:
18. Remove the "Field Upgrade Only" sticker from the bezel of the Upgrade Blade Link. This is
no longer a Field Upgrade Blade Link because the serial number and UUID have now been
programmed.
19. If the enclosure uses Virtual Connect, then the Monarch Server VCM server profile should now
be assigned to the enclosure bays occupied by the upgraded server. The profile may need
some modifications after it is assigned to the upgrade so that network assignments and other
elements of the VC server profile match what is required. See
profile mapping on the upgraded server blade" (page 82)
Portable Image tool is used (see
Portable Image" (page
is completed and any changes then should be made very carefully. Once assigned, verify
that there are no errors indicated by VCM or by the OA. Any VCM Domain Status or OA
System Status alerts or warnings should be resolved before proceeding. Sometimes, VCM
problems can be corrected by unassigning then reassigning the VC server profile.

Final hardware check

1. Log into the Monarch iLO 3 MP and power on the server by entering pc
Menu prompt or pressing the server power button.
2. Boot to the UEFI shell for a basic system check. Do not autoboot any currently installed operating
systems.
3. Complete the following checks to be sure that the upgraded server blade is functioning properly.
Any problems found in the steps immediately below should be resolved before proceeding.
a. Check the iLO 3 MP SEL for any problems. See
more information on resolving any errors.
IMPORTANT:
b. Execute the UEFI shell command lanaddress and verify that the expected number of
LAN ports are shown and that there is a link indication for every port that is connected
to a network or network switch.
NOTE:
NOTE:
embedded Flex- 1 0 LOMs, regardless of the active VC profile configuration. If the profile
specifies additional Flex- 1 0 LOM ports, those will become available while the operating
system runs.
78 Optional components
Manufacturer
Product Name (prodname)
Secondary Product Name
Product Number (prodnum) : AM358A
Secondary Product Number : AM358A
Serial number (serial)
Secondary serial number
UUID (uuid)
Secondary UUID
Product ID
84)), then it's best not to make changes until after the entire upgrade
If any errors are found in the SEL, do not continue until resolving them.
You should see an M on each applicable line.
lanaddress and other EFI commands will only list 4 LAN ports for each blade's
: HP
: Integrity BL870c i2
: Integrity BL870c i2
: USA0003
: USA0003
: 89742B3C-AD78-11DF-BB2A-5ABBD7A51B74
: 89742B3C-AD78-11DF-BB2A-5ABBD7A51B74
: 0x702
"Preserving VC-assigned MAC addresses in HP-UX by enabling
"Errors and error logs" (page 101)
"Possible changes due to VC
for more information. If the HP-UX
on at the Command
for