Bench Repairs: Drop Axle And Kingpin Housing Assemblies - Cub Cadet Domestic Series 7000 Service Manual

Domestic Series 7000 MFD
7.15. To remove the bearing it may help to slide the
axle shaft out roughly 1/4" (6mm). Once suffi-
cient grip is available to withdraw the bearing,
push the axle back into place.
NOTE: If the axle shaft is pulled-out too far, the
shims that are used to set ring gear component
of the differential back-lash may fall out of place.
If this happens, the axle housing must be
removed from the tractor and separated to repo-
sitions the shims.
8. BENCH REPAIRS: DROP AXLE AND KING-
PIN HOUSING ASSEMBLIES
8.1. Once on the bench, the drop axle housing and
the kingpin housing are easily separated from
each other by twisting and pulling.
8.2. To remove the kingpin shaft, bearing, and gear
from the kingpin housing, fixture it in a soft-jaw
vise.
8.3. Carefully drive the kingpin shaft out the bottom
of the kingpin housing. See Figure 8.3.
Drift
Figure 8.3
NOTE: There is a snap ring in the bore of the
kingpin housing that provides a stop for the bot-
tom of the stub shaft, and locates the top of the
bearing. Ensure that it is securely in place when
reassembling the kingpin housing.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
8.4.
14 tooth
bevel gear
8.5.
Kingpin shaft
42
With the kingpin shaft removed, the 14 tooth
bevel gear can be removed. See Figure 8.4.
Long spline
Figure 8.4
The bearing that supports the top of the kingpin
shaft can also be pushed out of the kingpin
housing with light pressure. See Figure 8.5.
Figure 8.5
Kingpin shaft
Short spline
/ pilot