Step 1. Inspect & Unpack
Upon receipt, inspect air compressor for missing or
damaged parts. Verify that it is the compressor you
ordered.
See "Component Identification" section of this manual
for a diagram of the compressor and its components.
For missing components, contact Product
Support at 1-800-270-0810.
For damaged components, contact the freight
company that delivered the unit and file a claim.
If complete, fill out product serial number
information. See "Limited Warranty" section of
this manual.
Components:
Air Compressor
Fasteners:
Rubber Feet
5/16" x 3/4"" Bolt
Qty 4
Part # 2215
Part # 82015
Figure 1
5/16" Nyloc Nut
Qty 4
Qty 4
Part # 82020
Figure 2
Initial Set-Up
Remove from pallet:
1. Remove and discard the tie strap.
2. Unbolt the compressor feet by removing the lag
bolts and washers and discarding them.
(Figure 3)
Lag Bolt
Attach rubber feet:
1. Attach handle and rubber feet as shown.
(Figure 4)
Step 3. Select Suitable Location
WARNING: Lifting hazard
The compressor is heavy. Ensure that proper lifting
equipment is available to unload and move compressor
to installation site.
WARNING: Location hazards
Choose a suitable site for operating your compressor to
prevent possible death from carbon monoxide
poisoning or injury from fire/explosion, hot surfaces or
equipment tip-over.
10
Step 2. Assembly
Figure 3
5/16" Nyloc Nut
5/16" x ¾" Bolt
Figure 4
Tie Strap
Rubber Feet