REMOVING THE THERMAL FUSE & EXHAUST THERMISTOR
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Unplug dryer or disconnect power.
2.
Turn off gas supply to dryer.
3.
Remove the front panel from the dryer
(see page 4-8 for the procedure).
4.
Remove the three screws from the lint
duct and remove the duct.
Lint Duct Screws
5.
Disconnect the two wire connectors from
the thermal fuse or exhaust thermistor
terminals.
6.
Remove the screw(s) from the thermal
fuse or exhaust thermistor and remove
the component from the blower housing.
Thermal Fuse
2 RD Wires
Blower Housing
4-9
Exhaust Thermistor
2 RD-WH Wires
2 Screws
1 Screw
Need help?
Do you have a question about the Duet Sport WED8300SW and is the answer not in the manual?
Questions and answers