Whirlpool 8178501A Manual page 19

9. To remove the user interface board:
a) With the back of the dispenser cover
assembly facing up, disconnect the ice
and water pad switch connectors.
b) Disconnect the user interface ribbon
cables from the user interface board.
To do this, lift the locking tabs, and pull
the cables out of the connectors.
c) Remove the four screws from the user
interface board, and remove the board
and its cover from the dispenser cover
assembly.
Lift Locking
Tabs
Water & Ice Pad
Switch Connectors
User Interface
Board Cover
Board Screws
User Interface Board
10. To remove the user interface:
a) Remove the user interface board (see
step 9).
Dispenser Cover
Assembly With Board
Lift Ribbon
Cable
Back Of
Removed
b) Carefully lift one of the corners of the
user interface, and peel it off the dis-
penser cover assembly.
11. To remove the dispenser light (LED)
assembly:
a) With the back of the dispenser cover
assembly facing up, disconnect the
wire connector from the user interface
board.
b) Push out on either of the two tabs, and
pull the light assembly off the dispenser
cover assembly.
Pull Out Dispenser Light Assembly
Connector
Dispenser Light Assembly
Continued on the next page.
3-5
User Interface
Push Out Tab