Whirlpool 8178501A Manual page 17

6. To remove the ice door motor:
a) Remove the two screws from the ice
door assembly, and remove the as-
sembly from its housing.
b) Disconnect the motor wire connector
from the core board at P5.
Screws
Ice Door
Assembly
Motor P5
c) Push down on the blue quick disconnect
locking ring, and pull the water tube from
the fitting (see the top right photo).
d) Release the two clips, and pull the
nozzle & ice guide out just far enough
to remove the motor wires and connec-
tor, then remove the ice door assembly
from the dispenser.
Ice Door Motor
Core Board
3-3
Motor Wires
Clip
Nozzle & Ice Guide
e) Remove the two screws from the motor
and remove the motor from the ice door
assembly housing.
Ice Door Motor Screws
Ice Door Motor
Continued on the next page.
Water Tube
Clip
Quick-Disconnect