Keyboard Commands; Entering Commands - GE MDS 4710A Technical Manual

MDS 05-3305A01, Rev. E
2. The display shows the first of 15 menu items. To review settings,
press the key. This controls the NEXT function. To change
E
parameter settings, press the
tion.
3. Configure the HHT as listed in
Table 8. HHT Operational Settings
Parameter
Re-init HHT
Baud Rate
Comm bits
Parity Error
Key Repeat
Echo
Shift Keys
Ctl Chars
NOTE: In rare cases, it might be necessary to reset the HHT to its
factory defaults before any configuration can be performed. To
do this, hold the
while plugging in the power cable into the HHT.

4.3 Keyboard Commands

Table 9 on Page 19 is a reference chart of software commands for the
transceiver. Programmable information is shown in brackets [ ] fol-
lowing the command name. See
Descriptions (Page 21) for detailed command descriptions.

Entering Commands

To enter a command, type the command, and then press the
key.
For programming commands:
1. Type the command.
2. Press the key.
SPACE
The appropriate information or values follow.
key.
3. Press the
ENTER
MDS 4710/9710 Technical Manual
key. This controls the ROLL func-
A
Table 8.
Setting Parameter
NO Scroll On
9600 Cursor
8,1,n CRLF for CR
OFF Self Test
OFF Key Beep
OFF Screen Size
YES Menu Mode
PROCS
and
ENTER
CTRL/Z
Section 4.4, Detailed Command
Setting
33rd
ON
OFF
FAST
ON
80
LONG
keys simultaneously,
ENTER
17