List Of Live Streaming Error Displays; Tally Lamp; Warning Tone - JVC GY-HM650U Instructions Manual

List of Live Streaming Error Displays

The following error messages are displayed when the live streaming setting is incorrect, or when the
connection is lost during live streaming.
Error message
Invalid Address.
Multicast Is Not Supported.
Cannot Connect to Receiver. Establishment of connection with
TCP Disconnected.
Not Enough Bandwidth.

Tally Lamp

The tally lamp start blinking when the remaining space on the SD card is running out during recording, or
when the battery power is running low.
Blinking Mode
Blinks slowly
(once every second)
Blinks quickly
(2 times per second)

Warning Tone

Warning tone is output from the monitor speaker and [x] terminal when the battery level is low.
0
Warning tone is also output when an error occurs in the camera recorder.
0
Memo :
You can specify whether to turn on the warning tone as well as setting the volume in [A/V Set] B [Audio
0
Set] B [Alarm Level].
(A P111 [ Alarm Level ] )
Status
The IP address format is
0
incorrect.
The domain name cannot be
0
converted into the IP address.
A multicast address has been
0
specified for TCP.
An IP multicast address was
passed.
TCP failed.
TCP connection is lost.
The communication bandwidth
0
is narrower than the average bit
rate.
The network bandwidth is
0
insufficient, and packets are
discarded.
Remaining Battery Power/SD Card Space
Battery power is low
0
Remaining recording time on SD card is less than 3 minutes (during
0
recording)
Remaining recording time on SD card is zero (during recording)
0
Error on the camera recorder
0
Action
Enter the IP address or host
0
name of the destination
correctly.
(A P166 [Setting Distribution] )
Use an IP address that is not a
0
multicast address.
Use an IP address that is not a
multicast address.
Ensure that the recipient's
0
device is set to TCP.
Set Type to "MPEG2-TS/UDP".
0
(A P166 [Setting Distribution] )
Check to ensure that there is no
abnormality in the decoder, or
network connection device and
cables, followed by establishing the
connection again.
Lower the resolution/picture
0
quality of the video to be
distributed.
Consider switching to the use of
0
a stable network, such as wired
LAN.
171