JVC GY-HM650U Instructions Manual page 127

Memo :
This item is not displayed when [Main Menu] B
0
[LCD/VF] B [Display Settings] B [Media
Remain] is set to "Off". However, warnings will
be displayed.
(A P108 [ Media Remain ] )
Displayed in the Display 0 and Display 1 screens
0
during warnings only. (When the remaining time
is shorter than 3 minutes)
The displayed time is an estimate.
0
D Frame rate
Displayed as xx/yy fps (xx: recording frame rate,
yy: playback frame rate) only when [Rec Mode]
is set to "Variable Frame".
(A P116 [ Rec Mode ] )
E Resolution
Displays the video image resolution.
Memo :
This item is not displayed when [Main Menu] B
0
[LCD/VF] B [Display Settings] B [Record
Format] is set to "Off".
(A P107 [ Record Format ] )
F Frame Rate/Bit Rate
Displays the frame rate and bit rate in pairs.
Memo :
This item is not displayed when [Main Menu] B
0
[LCD/VF] B [Display Settings] B [Record
Format] is set to "Off".
(A P107 [ Record Format ] )
G Audio Level Meter
Displays the audio levels of CH1 and CH2.
0
a appears on the screen when in the Auto
0
mode.
4030 20
When [Rec Mode] B [Rec Mode] is set to
.
0
"Frame Rec", "Interval Rec", or "Variable
Frame", audio cannot be recorded and is
indicated by the x mark.
4030 20
.
Memo :
This item is not displayed when [Main Menu] B
0
[LCD/VF] B [Display Settings] B [Audio Meter]
is set to "Off".
(A P108 [ Audio Meter ] )
10 0
10 0
H GPS Mark
When [Main Menu] B [System] B [GPS] is set
to "On", the signal reception status is displayed.
(A P112 [ GPS ] )
Memo :
The display changes according to the signal
0
reception sensitivity. If signals cannot be
received, the H mark appears in yellow.
This item is not displayed when [GPS] is set to
0
"Off".
I Volume Operation Indicator
Displayed when there are changes made to the
volume of the headphone, speaker (0 to 15),
and the values of LCD BRIGHT, PEAKING (-10
to +10).
LCD BRIGHT
PEAKING
.
Memo :
There is no audio output from the speaker in
0
Camera mode.
J Flash Band Correction Mark
This item is displayed when [Main Menu] B
[Camera Function] B [Flash Band Correction] is
set to "On".
(A P96 [ Flash Band Correction ] )
K Image Stabilizer Mark
Displayed when the image stabilizer is ON.
: When [Level] of [OIS] is set to
i
"Normal".
: When [Level] of [OIS] is set to
j
"High".
Memo :
If image stabilizer is set to "OFF" when the
0
Display 0 screen is displayed, h appears for 3
seconds.
Displayed in the Display 0 screen only when
0
there is a change.
0
12
-10
0
127