Table of Contents
Advertisement
Sound Projector
19
Custom Sound Projector menu
Manual Setup Option
Microphone
/
on a tripod or
on the back-
rest of your
seat
TV
,/
6
ft.
minimum
+----------+
Microphone Placement
•
Place the microphone at least
6
feet away from the
TV, centered in front of the TV.
•
Place the microphone on a flat, level surface such
as on a tripod or on the backrest of your seating.
•
Place the microphone where yours ears would be
when watching TV. Place it within
3
feet height from
the TV Speakers.
---------f
3ft
..._+-..,
TV Speakers-
!' ! -_
t
Adjusting Levels
1.
Adjust Center Level to the mid level.
2.
Adjust individual beam one at a time so that each
one sounds about the same as the center level.
3.
Check all sound levels by quickly switching
between them using ....
T.
4.
Readjust individual levels in small increments.
Auto Setup Option
(153 or 249 series only)
1.
Plug the microphone into the left audio jack of
the side panel (INPUT
3).
If the microphone is not
plugged in, the TV will not allow the Auto setup.
2.
Set Mode to Auto. START is displayed in place of
Custom. Highlight START and press ENTER.
3.
Quietly exit the room right away as your presence
will interfere with the calibration process.
4.
Return to the room after the completion of setup.
5.
Play some sample audio to check the sound quality.
Note:
Do not perform manual adjustments after the
Auto setup. Auto calibration data will be erased.
6.
Store the microphone out of direct sunlight and
away from heat.
Sound to be equal in both ears.
Maximize the sound from the left.
Maximize the sound from the right.
Adjust as if the sound comes from
the left rear side, or same as that
for Left Angle.
Adjust as if the sound comes from
the right rear side or same as that
for Right Angle.
TV Location
TVW.II
Othor Wall
TV
to
Sofa
length
longth
./ Center
16
feet
14
rett
12 (eet
Custom
left
D
l Corner
Right
R Corner
(!)
Center Angle
Left Angle
Right Angle
Right Sur-
round Angle
•
To reset the beams, change the TV Location field.
•
At extreme beam angles, the image on screen may
not be accurate.
1.
From the Initial> SoundPro menu, enter the room
dimensions and layout information requested in the
screen. Press ....
T to specify the value.
2.
Highlight Custom and press ENTER to fine tune the
direction and focus of the TV's sound output.
153 and
249
Series: Select Manual option under Mode (refer to
the page
16),
for Custom button to
be
displayed.
The TV's bank of speakers can be adjusted to reflect
sound off the room walls to create a surround sound
effect. Setup can be performed manually for all models,
and
lor
automatically depending on your TV models.
Adjusting Angles
1.
Position yourself in your usual viewing location.
2.
Press ....
T
to seiect an audio beam.
3.
Press
<II
~
to redirect the audio beam or change
the sound level.
Hide quick links:
Advertisement
Table of Contents
