Install/Replace The Remote Control Battery; Install/Replace The Clock Battery Backup; Maintenance - Timex Ti700 Quick Start Manual

The remote control battery is already installed at the factory. When the remote control stops operating or its range seems
reduced, it is time to replace the battery with a new one.
1. The battery door is located on the back end of the unit.
2. Slide the battery door open and remove old battery.
3. Insert a CR2032 battery, checking that the + and – ends of the battery
match the drawing inside the battery compartment.
4. Replace the battery door.
Note: Make sure you dispose of battery properly (see your local regulations).
The Remote Control controls basic functions on the Ti700 and certain iPod
functions when the iPod is docked in the Ti700. For best results, aim remote
control towards the remote sensor on the upper right corner of the unit.
To check for iPod compatibility
The Ti700 is an advanced system and supports most updated iPod features. To ensure your iPod works properly with the
Ti700, please update your iPod firmware with the latest version. Please check the Apple website (www.apple.com) for
updates.
The Ti700 used 2 "AA" batteries backup battery system to provide continuous alarm operation and clock settings in the
event of a power failure. If the Backup Battery has been installed and a power failure occurs or the AC adaptor is accidentally
disconnected, the display backlight will not remain lit, but the current time and alarm time settings will be temporarily
maintained. Otherwise, you must reset the time and alarm settings.
If the unit has no display or the Backup Battery Low Icon located on the top of the display is flashing, it is time to replace the
backup batteries.
1. Please make sure the AC adaptor is connected. Otherwise all settings may be lost during battery replacement.
2. Open backup battery compartment cover located on the bottom of the unit.
3. Insert two "AA" batteries, checking that the polarity ( + and - ends of the batteries) matches the drawing near the battery
compartment. Close the compartment cover.
l
Place the unit on a level surface away from sources of direct sunlight or excessive heat.
l
Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material
should be placed between it and the furniture.
l
Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzine,
thinner or similar materials can damage the surface of the unit.

Install/Replace the Remote Control Battery

Install/Replace Clock Battery Backup

Maintenance