Advertisement
Remote not included
with all Ti72
models.
To order a remote,
please visit
www.timexaudio.com
Installing/Replacing the Remote Control Battery
The remote control battery is already installed at the factory. When the remote control
stops operating or its range seems reduced, it is time to replace the battery with a
new one.
1. The battery door is located on the back end of the remote.
2. Slide the battery door open and remove old battery.
3. Insert a CR2032 battery, checking that the + and – sides of the battery
match the drawing inside the battery compartment.
4. Replace the battery door.
Note: Make sure you dispose of all batteries properly (see your local regulations).
CAUTION: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Using the Optional Remote Control
Pressing Play/Pause from power off mode will play iPod.
Pressing Play/Pause while iPod is docked and playing will pause iPod.
Press again to resume play.
Power Button turns unit ON and OFF or resets alarm when alarm is sounding
Pressing FWD/REW while iPod inserted will FWD/REV to next/previous track
Pressing and holding FWD/REV while iPod is docked will scan forward/reverse
within currently playing track.
Volume Buttons raise and lower volume on the unit.
Pressing Sleep Button will select an amount of time before the Ti72 shuts off:
90, 60, 30 or 15 minutes (OFF shuts unit off)
Pressing the mute button will mute unit.
Snooze/Dimmer Button snooze mode when alarm sounds, otherwise dims display
7
Install Remote Control Battery
Advertisement
