ProStart CT-3471 TW User Manual
  1. Manuals
  2. Brands
  3. ProStart Manuals
  4. Remote Starter
  5. CT-3471 TW
  6. User manual

ProStart CT-3471 TW User Manual

Two-way 6-button lcd automatic/manual transmission remote starter
Hide thumbs Also See for CT-3471 TW:
Table of Contents

Advertisement

Quick Links

T W O - W A Y
6 - B U T T O N
Depending on your usage of the transmitter, the battery can last anywhere between 3 to 6 months. When the
battery is low, the transmitter will produce two beeps in a repetitive cycle. At that point you should replace
your battery with a new one. That is why we recommend that you keep a spare battery somewhere handy
such as the glove compartment.
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.
Doc#: 110602
L C D
A U T O M A T I C / M A N U A L
R E M O T E
CT-3471 TW
User Guide
It is the responsibility of the vehicle operator to ensure their vehicle is parked
in a safe and responsible manner.
1. a) Manual transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in the NEUTRAL position and
the parking brake is engaged in order to avoid accidents upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in "Park" in order to avoid
accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is disabled or put
into valet mode before servicing.
A note concerning the battery inside the transmitter:
Rev: 1.3
© 2011
S T A R T E R
WARNING !
- CT-3471TW -
T R A N S M I S S I O N
-FcN-
Canada

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CT-3471 TW and is the answer not in the manual?

Questions and answers

Rob
March 15, 2025

Ct 3471tw feedback quit working

0
1 comments:
Mr. Anderson
March 15, 2025

The ProStart CT-3471 TW may have stopped working due to a module reset, which erases all programmed values such as the tach, transmitter, and programming options, returning them to default settings. This could require reprogramming to restore functionality. Another possibility is a misunderstanding of its features or improper installation.

This answer is automatically generated

0

Related Manuals for ProStart CT-3471 TW

Summary of Contents for ProStart CT-3471 TW

  • Page 1 T R A N S M I S S I O N R E M O T E S T A R T E R CT-3471 TW User Guide WARNING ! It is the responsibility of the vehicle operator to ensure their vehicle is parked in a safe and responsible manner.

  • Page 2: Table Of Contents

    ........................15   TYLE LARM ......................15   NTRUSION ODES VIA HORN MULTI-LEVEL FEATURES ......................16   TROUBLESHOOTING POOR TRANSMITTING RANGE ............... 17   PARKING LIGHT FLASH TABLE ....................18   PROSTART LIMITED LIFETIME WARRANTY ................19   User Guide...

  • Page 3: Introduction

    Introduction    This is a state-of-the-art remote car starter system. The system is packed with advanced features such as priority access to the driver’s door (commodity features), the Safe Start children safety feature and SmartStart™. SmartStart™ is a groundbreaking technology that enables your remote starter features to be accessed by your smartphone.

  • Page 4: Basic Vehicle Operations

    Note: If you wish to exit a function while still in the process of accessing it, simply stops and wait at least 10 seconds: the transmitter will return to its normal state. The functions of the transmitter are as follows: Function Button: .

  • Page 5: Transmitter Mode Selection

    Transmitter Mode Selection  Function Button pressed Icon sound Instructions /description Press and hold Vibration mode Vibrates 4x and then press Press once to have Alarm clock mode alarm clock on Melody on/off Press twice to have alarm clock off How to access remote’s function menus:  User Transmitter appears on screen.

  • Page 6: Arming And Disarming The Starter Kill

    Once the Countdown is activated it will continue counting down until reaching 0:00. If the Timer has not reached 0:00 and you are starting the vehicle, you should reset your Countdown Timer to 0:00 before starting your vehicle as to avoid being startled. Arming and disarming the Starter Kill ...

  • Page 7: Remote-Starting Your Vehicle

    Remote­Starting Your Vehicle  Setting Your Vehicle Into Ready Mode  If your vehicle has a manual transmission you must read the following indications. The unit must first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready Mode, it cannot remote start the vehicle.

  • Page 8: Remote­starting

    Remote­starting  Press the button. The remote will beep once. Approximately 5 seconds later, the remote will play a start melody to confirm the remote starter’s activation. If your vehicle has an automatic transmission and it does not start at the first attempt, the system will shut down, wait a few seconds and try to start the engine again.

  • Page 9: Valet Modes

    With the engine running, make sure to release the brake pedal and press the button on the transmitter until the parking lights come ON. Remove the ignition key from the ignition switch. The engine will continue running. Exit the vehicle and close all doors, hood and trunk. Press the button to lock the doors, to arm the starter kill and to arm the OEM style alarm.

  • Page 10: Panic Mode

    To take the system out of Valet Mode  To take the system out of Valet mode using the KEY (Ignition Valet Mode): Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times successively into the IGNITION/RUN and OFF positions. The parking lights will flash twice. Turn the ignition OFF.

  • Page 11: Extended Run Time

    To exit Cold Weather Mode, do any one of the following actions: • Open the hood. • Start the engine by remote. • Turn the ignition key to the IGNITION ON (RUN) position. • Press the for 1 second and release. The remote will beep once and will appear on the display.

  • Page 12: Missing A Start Or A Stop Confirmation

    Missing a Start or a Stop Confirmation  If you have not received a Start or the Stop confirmation after pressing the button, pressing the button will refresh the display and will confirm if the vehicle was started or stopped. If no Start Confirmation Was Received: • Press the button: The remote’s...

  • Page 13: Safe Start

    Safe Start  This feature will eliminate accidental remote starts, e.g. when children are playing with the transmitter. Safe start enabled: If this feature is enabled, the user must press the button twice within 3 seconds to remote-start the vehicle. Swap start: If this feature is enabled; Press the for 1 second and release.

  • Page 14: Home Valet Tm " Mode

    “Home Valet ” Mode  If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if the vehicle is parked indoors there is no danger of it starting accidentally by remote control. If the vehicle has a manual transmission, it should be set into ready mode before activating the Home Valet™.

  • Page 15: Oem-Style Alarm

    • Press : ..........LOCK • Press ..........UNLOCK • Press : ..............START • Press ............ STOP • Press ..........TRUNK Start/Stop While in Safe Start Mode Function Button press Icon Sound Description Press simultaneously twice within 3 Start on safe start seconds.

  • Page 16: Multi-Level Features

    Multi­Level Features  Basic Features (press the button 1X) Level 1 ............. aux 2 ............. cold weather Multi-Car Operation (press the button 2X) Level 2 ....... car lock ....... : 2nd car unlock ....... : car start/stop ....... car trunk Customized Features (press the button 3X) Level 3 (May not be compatible with some vehicles)

  • Page 17: Troubleshooting Poor Transmitting Range

    Option 1: Level 1 (requires pressing the button 1X) Multi car operation Level 2 (requires pressing the button 2X) Basic features Level 3 (requires pressing the button 3X) Customized features Option 2 (by default) Level 1 (requires pressing the button 1X) Basic features Level 2 (requires pressing the button 2X)

  • Page 18: Parking Light Flash Table

    • The operating range will be somewhat lower on vehicles equipped with an aftermarket or factory alarm. Parking Light Flash Table  Parking lights flashes Description • Doors locked. • Trunk released. • Start signal received from the remote. • Runtime has expired • 2 slow Shutdown by remote •...

  • Page 19: Prostart Limited Lifetime Warranty

    (only) and a copy of the proof of purchase, freight prepaid, along with their name, address and telephone number, to the PROSTART SERVICE CENTER for the exchange to take place. MODULES RETURNED TO THE POINT OF PURCHASE AFTER THE ONE-YEAR REPLACEMENT PERIOD WILL NOT BE ACCEPTED. A module will be returned to the consumer, freight collect, within 4 weeks of receipt of the module.

Table of Contents

Save PDF