Table of Contents
Advertisement
A U T O M A T I C
W A Y
A note concerning the battery inside the transmitter:
Depending on the usage of the transmitter, the battery can last anywhere between 3 to 6
months. When the battery is low, it the transmitter will emit two beeps in a repetitive
cycle. At that point you should replace your battery with a new one. That is why we
recommend that you keep a spare battery somewhere handy such as the glove
compartment.
DOC: 2.63
- CT-3400TW -
T R A N S M I S S I O N
L C D
R E M O T E
CT-3400 TW
User Guide
It is the responsibility of the vehicle operator to ensure
their vehicle is parked in a safe and responsible
manner.
1. When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in
"Park" in order to avoid accidents upon remote
starting.
2. It is the user's responsibility to ensure that the
remote starter is disabled or put into valet mode before
servicing.
- September 5, 2007 -
M U L T I - C H A N N E L
S T A R T E R
S Y S T E M
WARNING
- MO -
T W O -
Assembled in Canada
Advertisement
Table of Contents
Related Manuals for ProStart CT-3400 TW
Summary of Contents for ProStart CT-3400 TW
- Page 1 R E M O T E S T A R T E R S Y S T E M CT-3400 TW User Guide A note concerning the battery inside the transmitter: Depending on the usage of the transmitter, the battery can last anywhere between 3 to 6 months.
-
Page 2: Table Of Contents
Confirmations..........8 Engine Run Time.........14 Basic Operations (Second Car Control) 8 Multi-car Operation......14 Start/Stop While in Safe Start Mode..8 Diagnostics..........15 Timing and Alarm Adjustment....8 PROSTART LIMITED LIFETIME Remote-starting Your Vehicle....9 WARRANTY..........16 Vehicle Presets...........9 P. 2 User Guide CT-3400 TW... -
Page 3: Transmitter Part Number And Module Serial Number
By using narrow band filtering and unique software driven noise filters, the radio set is able to achieve much better input sensitivity resulting in up to 2,000 feet of operating range. CT-3400 TW User Guide P. 3... -
Page 4: Lcd Remote Functions
Please refer to your installer to see if your vehicle is compatible with this option. ) button is used to access all advanced functions of the remote control. (Refer FUNCTION to the LCD Operation and Confirmations tables.) P. 4 User Guide CT-3400 TW... -
Page 5: Alarm Clock
Flashing LED OFF: The LED will not flash when the Module is armed (passive or active • arming). However, if the Module is in Valet Mode, the LED will remain on solid when the Ignition is “OFF”. CT-3400 TW User Guide P. 5... -
Page 6: Lcd Remote Operation
Press the to decrease the value or to activate or deactivate a function or to toggle through the melodies. P. 6 User Guide CT-3400 TW... -
Page 7: Cold Weather Mode
Once the countdown is activated it will continue counting down until reaching 0:00. If the timer has not reached 0:00 and you are starting the vehicle, you should reset your countdown timer to 0:00 before starting your vehicle as to avoid being startled. CT-3400 TW User Guide P. 7... -
Page 8: Safe Start Mode
To apply changes to the hours, minutes melody, etc. you must press and hold the function button for three (3) seconds after which the hour position will start to flash. To navigate through the options, simply press the function button until you reach the desired position. P. 8 User Guide CT-3400 TW... -
Page 9: Remote-Starting Your Vehicle
The engine will go on running. It will shut down when the pre-programmed run time expires. Caution: Do not leave children or pets unattended in a car running in Idle Mode. Note: When enabling Idle Mode, pressing will LOCK UNLOCK unlock the doors (if remote door locks are installed). CT-3400 TW User Guide P. 9... -
Page 10: Turbo Mode
Valet Mode will prevent the engine from being accidentally started by remote control. To ENTER Ignition Valet Mode With the key in the Ignition switch, turn the key to the and then ON (RUN/IGNITION) positions 5 times within 10 seconds. P. 10 User Guide CT-3400 TW... -
Page 11: Panic Mode
1 sec. UNLOCK The parking lights will flash twice and the LED will turn off to confirm that the doors have been unlocked and that the starter kill feature is disarmed if it was installed. CT-3400 TW User Guide P. 11... -
Page 12: Cold Weather Mode
• Safe Start • Remote Trunk Release • Starter Kill/Anti-Grind • Engine Run Time • Passive or Active Arming Starter Kill • Turbo Mode (Turbo Cars) • Ignition-controlled Door Locks • Horn Honk on Lock P. 12 User Guide CT-3400 TW... -
Page 13: Remote Door Locks Option
With this added security feature, the system will prevent your vehicle from starting with the Ignition key when the starter kill is armed. If your ProStart was installed with the starter kill option, you will not be able to start your vehicle with the key unless the system has been unlocked first. -
Page 14: Remote Trunk Release Option
Starting the vehicle in Safe Start Mode: ♦ Press TRUNK + START/STOP ♦ Within 3 seconds press again. TRUNK + START/STOP Stopping the vehicle in Safe Start Mode: ♦ Press once. TRUNK + START/STOP P. 14 User Guide CT-3400 TW... -
Page 15: Diagnostics
If the unit gives irregular signals (1 to 10 flashes followed by a pause, followed by Irregular further flashes), the system is playing back start failure codes. This occurs when the hood pin-switch is pressed three times Constant flashes • Panic mode is triggered. up to 25 sec. CT-3400 TW User Guide P. 15... -
Page 16: Prostart Limited Lifetime Warranty
(only) and a copy of the proof of purchase, freight prepaid, along with their name, address and telephone number, to the PROSTART SERVICE CENTER for the exchange to take place. MODULES RETURNED TO THE POINT OF PURCHASE AFTER THE ONE-YEAR REPLACEMENT PERIOD WILL NOT BE ACCEPTED.
Need help?
Do you have a question about the CT-3400 TW and is the answer not in the manual?
Questions and answers