Table of Contents
Advertisement
EBU01570
Tires
q WARNING
POTENTIAL HAZARD
Operating this ATV with improper tires, or
with improper or uneven tire pressure.
WHAT CAN HAPPEN
Use of improper tires on this ATV, or oper-
ation of this ATV with improper or uneven
tire pressure, may cause loss of control,
increasing your risk of accident.
HOW TO AVOID THE HAZARD
1. The tires listed below have been
approved by Yamaha Motor Co., Ltd.
for this model. Other tire combinations
are not recommended.
Manufacturer
Front
DUNLOP
Rear
DUNLOP
Size
Type
KT341
AT21 × 7–10
Radial
KT345
AT20 × 10–9
Radial
2. The tires should be set to the recom-
mended pressure:
8 Recommended tire pressure
Front 27.5 kPa (0.275 kgf/cm
Rear
27.5 kPa (0.275 kgf/cm
8 Check and adjust tire pressures when
the tires are cold.
8 Tire pressures must be equal on both
sides.
3. Tire pressure below the minimum
specified could cause the tire to dis-
lodge from the rim under severe riding
conditions.
The following are minimums:
Front 24.5 kPa (0.245 kgf/cm
Rear
24.5 kPa (0.245 kgf/cm
4. Use no more than the following pres-
sures when seating the tire beads.
Front 250 kPa (2.5 kgf/cm
Rear
250 kPa (2.5 kgf/cm
Higher pressures may cause the tire to
burst. Inflate the tires very slowly and
carefully. Fast inflation could cause
the tire to burst.
5-8
2
, 4.0 psi)
2
, 4.0 psi)
2
, 3.5 psi)
2
, 3.5 psi)
2
, 36 psi)
2
, 36 psi)
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the RAPTOR 700 and is the answer not in the manual?
Questions and answers
Changed relay , changed fuel pump , changed fuses , new plug good battery got fire fuel I can’t hear when I turn key and switch on .
If a Yamaha Raptor 700 does not make any sound when turning the key and switch on after changing the relay, fuel pump, fuses, and spark plug, the issue could be related to:
1. ECM Connection Issue – The ECM may not be making proper contact due to pushed-down pins in the connector, which can prevent spark and power delivery.
2. Main Fuse – Check if the main fuse (20A) is blown and replace it if necessary.
3. Ignition System Wiring – Inspect the wiring from the ignition switch to ensure continuity and no loose or damaged connections.
4. Battery and Ground Connections – Verify that the battery is charged and properly connected, and ensure the ground connections are secure.
5. Tip-Over or Safety Switches – Check if the tip-over switch, clutch switch, or kill switch is malfunctioning or disconnected.
If these checks do not resolve the issue, further diagnosis of the ECM and ignition system may be required.
This answer is automatically generated