Table of Contents
Advertisement
EBU16020
Seat
To remove the seat, insert your hand between
the rear of the seat and the rear fender, pull the
seat lock lever, and then pull up the seat at the
rear.
1
1. Seat lock lever
To install the seat, insert the projections on the
front of the seat into the seat holders and push
down on the seat at the rear.
NOTE:
Make sure that the seat is securely fitted.
1
2
1. Projection (× 2)
2. Seat holder (× 2)
4-13
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the RAPTOR 700 and is the answer not in the manual?
Questions and answers
Changed relay , changed fuel pump , changed fuses , new plug good battery got fire fuel I can’t hear when I turn key and switch on .
If a Yamaha Raptor 700 does not make any sound when turning the key and switch on after changing the relay, fuel pump, fuses, and spark plug, the issue could be related to:
1. ECM Connection Issue – The ECM may not be making proper contact due to pushed-down pins in the connector, which can prevent spark and power delivery.
2. Main Fuse – Check if the main fuse (20A) is blown and replace it if necessary.
3. Ignition System Wiring – Inspect the wiring from the ignition switch to ensure continuity and no loose or damaged connections.
4. Battery and Ground Connections – Verify that the battery is charged and properly connected, and ensure the ground connections are secure.
5. Tip-Over or Safety Switches – Check if the tip-over switch, clutch switch, or kill switch is malfunctioning or disconnected.
If these checks do not resolve the issue, further diagnosis of the ECM and ignition system may be required.
This answer is automatically generated