Table of Contents
Advertisement
Troubleshootmg
•
Other
Problem
Possible causes and solutions
The TV operates Incorrectly.
- Some TVs with
wireles~
remote control capllbility may operale incorreclly when using
the remote control of Ihis Player. Use such TVs llway from fhis Player.
The Player heats up during use.
- When using
IhL~
Player. rhe console cabinet mllY heat up depending on the
u.~ge
environment.
Th'l~
is not a malfunction.
•
Messages Relating to BD disc and DVD disc
- The following messages appear on the TV screen in case the disc you tried to playback is not appropriate or the
operation is not correct.
Error message
Possible Error
Possible Error
Cannot play.
- The disc ClIllnot
be
played back with this Player.
- Check the disc. and load it correctly.
Incompatible disc.
-
I
f
you load a disc which cannot
be
played with
this Player (Le. a scmlched disc), or if you load
a disc upside down. rhis message will appear.
and the
d'l~
tnlY will aUfomatically pop out.
- Occurs if
the
loaded disc cannot
be
pIa
Jed
- Remove rhe
dL~.
because it is a non-standard disc or scrarched.
elC.
Cannot operate.
- Occurs if an operation is incorrect
This USB memory is not formatted
- Occurs if there is
11
furrnaning error.
- Formaf
the
USB memory again.
properly. Please format the memory In
-
Occurs if
the
USB memory is notJ(lrmatted
- Format
the
USB memory with your
USB memory management.
with FAT 32116.
PC.
The Connected USB Memory cannot
- Occurs if USB memory not compliant with
- Connect USB 2.0 High Speed
be used. It should be compliant with
USB 2.0 High Speed
(48(}Mbill~)
is used (i.e.
(4!10Mbilfs) compliant USB
USB 2.0
USB 1.0IUSB
1.J).
memory.
To Reset this Player
If this Player receives strong interference from a source such as excessive sUllic electricity, strong extemalnoise,
maUi.m~:tion
of power supply, or voltage caused by lightning during use or a wrong operation is sent to the Player, errors
like the Player not accepting an oper.ltion may occur.
CD
Press and hold
<9
on the Player until "RESET" appears on the front panel display when th", Player does not operate
properly even after the power has been turned oiT.
®
Tum on the power.
.
...
,
"~
N[jtBtI,H
- When a reset is performed while the power is on. the Player will turn oil'. Turn the power on again. At this point, it
may take a few moments for the system processing to jinish before the Player is ready for use.
- When the pmblem persiSL'i even after performing a reset, unplug the power cable and plug it in again. If this does
not solve the problem, contact the nearest service center approved by Yamaha.
Keylock function
You can set the key lock to pre·vent accidental opel1ltions. Press and hold. and ....
J~
on the front pand for more
than 4 secouds while no disc is insetted in this Player mtd the disc tray is dosed.
- Each time you perform this opel1ltion, the lilllction is a('tivated or deactivated.
- If you try to opel1lte the Player while the key lock fun('tiou is seL "Lock" blinks ontlte front panel display to indicate
that the keylock function is set.
41
En
•
Advertisement
Table of Contents
