Troubleshooting - Sanyo DC-HT818 Instruction Manual

Troubleshooting

Before resorting to maintenance service, please kindly check by yourself with the following
chart.
Symptom
The AC power cord is not connected
No Power
to the power supply or is not
connected to a power supply securely.
Picture
Video input mode of the connected
TV isn't correctly set.
There is no
Video output mode isn't correctly set.
picture or the
picture is
distorted.
The video cable isn't connected
securely.
Sound
The audio cables aren't connected
There is no securely.
The volume is set at the lowest level.
sound or the
The sound is switched off.
sound is
distorted.
The disc is in fast forward/rewind
playback.
This disc is placed in the disc tray
Unable to
in a wrong way.
play a disc
The rating of the disc is higher than
the rate set in the parental control item.
The unit isn't compatible with the
disc.
The disc is dirty.
The buttons
The unit is being interfered with
on the unit
static electricity etc.
doesn't work.
The remote There is no battery in remote
control does control.
not function.
The batteries are out of
installed incorrectly.
The remote control isn't pointed to
the remote sensor.
The remote control is out of its
operating area.
The unit is shut down.
The player
The connected USB drive or the
breaks down
memory card is probably not a
when a USB
certified one.
drive or a
memory card
is inserted
into the
player.
Cause(s)
charge,or
-23-
Remedy
Please check that the AC power
cord is connected securely.
Set an appropriate video output
mode.
Press [V-MODE] repeatedly
until the picture becomes normal
again.
Connect the video cable
securely.
Connect the audio cables
securely.
Turn up the volume.
Press [MUTE] on the remote
control to switch on the sound.
Press [PLAY/PAUSE].
Check that the disc is placed in
the disc tray with its label side
upwards.
Reset the settings in the
parental control item.
Place the compatible disc.
Clean the disc.
Switch off and unplug the unit.
Then connect the unit to the AC
supply and switch it on again.
Insert two AAA/1.5V batteries
in it.
Replace the batteries with new
ones or check the battery polarity
(+or-)
Make sure that the remote
control is pointed to the remote
sensor.
Make sure the remote control is
within the operating area.
Switch off the unit and disconnect
it from the AC outlet. Then power on
the unit again.
The player cannot play any
uncertified USB drive and memory
card.
In case the player breaks down, turn
it off, disconnect the power cord from
the AC outlet and unplug the USB
drive or/and the memory card from
the player. Then, power on the player
again. The player will resume the
normal status.