Function Of Components - Cub Cadet Sc2450 Operator's Manual

■ Function of Components

(1) Hazard lights button switch
Depress the red button to turn the hazard lights ON.
Pressing this button will cause the button to light up
and the hazard lights at the rear of tractor to flash.
(The hazard lights remain flashing even when the
starter key switch is in the OFF position. Remember
that allowing the turn signal/hazard lights to flash for
an extended period can lead to loss of battery
voltage.)
(a) ON
(b) OFF
(2) Starter key switch
This switch is used to start and stop the engine.
(A) OFF position:
The engine must be off.
(B) ON position:
When the key has been turned to this position,
the engine oil pressure warning light and the
alternator/battery charging light and the engine
coolant warning light will illuminate.
(C) START position:
When the key is turned to this position, the starter
starts turning the flywheel and then the engine
begins to run. Once the engine has started,
release the key.
(D) Preheating position:
Preheating time should be determined according to
outside air temperature. For details, see the table
below.
Temperature (°F (°C))
Over 32 (0)
Below 32 (0)
(A) OFF position
(B) ON position
(C) START position
(D) Preheating position
Sc2450 Operator's Manual
5. NAMES AND FUNCTIONS OF COMPONENTS
Preheating Time (sec.)
2 to 3
4
(a)
3013729
3014907a
5-3
(b)
(A) (B)
(D)
(C)