Assembling Remaining Bagger Components - Cub Cadet 19A30003100 Operator's Manual

4. Install the bag support assembly onto the mounting
assembly on the tractor by hooking it over the cross
mounting bracket outside of the two tabs. See Fig. 4-7.
5. Secure the bag support assembly to the mounting assembly
using a hex bolt (710-3008) and flange lock nut (712-04063)
provided in hardware pack 689-00087. See Fig. 4-8.
Note: On tractors with 42" decks the support assembly
mounts in the center hole as seen above in Fig. 4-8. On
tractors with 46" decks, the support assembly mounts in
the right hand hole as seen in Fig. 4-9.
10 s 4 — a
ectiOn sseMbly
Tabs
Top View
Figure 4-7
42" Decks
Figure 4-8
& i
nstallatiOn
Figure 4-9

Assembling Remaining Bagger Components

Now that the mounting brackets are assembled and are in place
on the tractor, follow these steps to assemble the remaining
bagger components.
1. Snap the plastic upper chute support in place by first
clipping the side portion onto the bag support rail with
the edge of the snap feature aligned with the red line (1), as
shown in the inset of Fig. 4-10.
2. Snap the front portion of the upper chute support to the
bag support rail as seen in 2 of Fig. 4-10.
2
Figure 4-10
46" Decks
1