Others - Panasonic SC-AP01 Operating Instructions Manual

Others

Wi-Fi signal strength
®
To check the Wi-Fi
is located.
Preparation
≥ Turn the unit on.
≥ Connect this unit to the wireless network. (
1
If this unit is in use, stop the AirPlay
playback to this unit.
≥ Wait for at least 15 seconds before
proceeding to step 2.
2
Press and hold both [– VOLUME] and
[VOLUME i] on this unit for more than 2
seconds.
3
The operation indicator lights and then
blinks a set number of times.
Count the number of times the indicator
blinks.
≥ A stable connection is available when the
operation indicator blinks 3 times.
Change the position or angle of your wireless network
router or the unit in the following cases:
– The operation indicator only blinks 2 times or 1 time.
– The sound is interrupted.
12
RQT9658
signal strength where the unit
®
Software update
Occasionally, Panasonic may release updated
software for this unit that may add or improve the
way a feature operates. These updates are
available free of charge.
6) Preparation
≥ Turn the unit on.
≥ Connect this unit to the wireless network. (
jMake sure that the wireless network is
connected to the Internet.
1
Press and hold both [– VOLUME] and
[– WPS] on this unit for more than 2
seconds.
{. The operation indicator (
DO NOT DISCONNECT the AC adaptor while
this unit is updating.
≥ During the update process, no other operations can be
performed.
≥ If the update is unsuccessful, the operation indicator
will blink in a specific sequence. (
2
The operation indicator lights when the
update has finished successfully.
≥ If the software update is not required, the
operation indicator turns off.
3
Disconnect the AC adaptor and reconnect
it after 3 minutes.
≥ Downloading will require several minutes. It may
take longer or may not work properly depending on
the connection environment.
If the update is unsuccessful, the operation indicator will
blink in a specific sequence.
No. of blinks
3
2
1
4) blinks.
below)
Problems and solutions
The software download has failed.
Please try again later.
The server cannot be found. Make
sure that the wireless network is
connected to the Internet.
This unit cannot connect to the
network. Check the network
connection.
The update has failed. Turn this unit
off and remove the AC adaptor.
Reconnect the AC adaptor and try
again.
6)